GE JGB902 Display goes blank, Display flashes, Unable to get, Display to show SF, Power outage

www.GEAppliances.com

Problem	Possible Causes	What To Do
Display goes blank	A fuse in your home may be	• Replace the fuse or reset the circuit breaker.
	blown or the circuit
	breaker tripped.
	The clock is in the	• See the Special features of your oven control section.
	black-out mode.
Display flashes	Power failure.	• Reset the clock.
Unable to get the	Oven control pads were	• The BAKE and BROIL HI/LO pads must be touched at
display to show “SF”	not pressed properly.	the same time and held for 3 seconds.
Power outage,	Power outage or surge.	• Reset the clock. If the oven was in use, you must reset
clock flashes		it by touching the CLEAR/OFF pad, setting the clock
		and resetting any cooking function.
“Burning” or “oily”	This is normal in a new oven	• To speed the process, set a self-clean cycle for a
odor emitting from	and will disappear in time.	minimum of 3 hours. See the Using the self-cleaning
the vent		oven section.
Strong odor	An odor from the insulation	• This is temporary.
	around the inside of the oven
	is normal for the first few times
	the oven is used.
Fan noise (some models)	The convection fan may turn on	• This is normal. The convection fan will run until the
	and off automatically.	function is over or the door is opened.
Convection fan not	Preheat temperature	• Fan will start automatically once the preheat
working (some models)	not reached.	temperature is reached.
Drawer does not slide	The drawer is out of alignment.	• Fully extend the drawer and push it all the way in.
smoothly or drags		See the Care and cleaning of the range section.
	Drawer is over-loaded or load	• Reduce weight. Redistribute drawer contents.
	is unbalanced.
Warming drawer will	A fuse in your home may be	• Replace the fuse or reset the circuit breaker.
not work	blown or the circuit breaker
	tripped.
	The oven is self-cleaning.	• Wait for the self-clean cycle to finish and the oven
		to cool.
	Controls improperly set.	• See the Electric warming drawer section.
Excessive condensation	Liquid in warming drawer.	• Remove liquid.
in the warming drawer
	Uncovered foods.	• Cover food with lid or aluminum foil.
	Temperature setting too high.	• Reduce temperature setting.
Food dries out in the	Moisture escaping.	• Cover food with lid or aluminum foil.
warming drawer

53

Safety Instructions Operating Instructions Installation Instructions Troubleshooting Tips Consumer Support