GE JGB920 Using the oven, Consumer Support, Installation Instructions Operating, Oven Vent

Instructions

Using the oven.

To avoid possible burns, place the shelves in the desired position before you turn the oven on.

Instructions Safety

The oven has 5 shelf positions.

It also has a special low shelf position (R) for extra large items, such as a large turkey.

Before you begin…

The shelves have stop-locks, so that when placed correctly on the shelf supports (A through E), they will stop before coming completely out, and will not tilt.

When placing and removing cookware, pull the shelf out to the bump on the shelf support.

To remove a shelf, pull it toward you, tilt the front end up and pull it out.

To replace, place the end of the shelf (stop- locks) on the support, tilt up the front and push the shelf in.

NOTE: The shelf is not designed to slide out at the special low shelf (R) position.

Installation Instructions Operating

Plastic items on the cooktop may melt if left too close to the vent.

Vent appearance and location vary.

Oven Vent

Your oven is vented through ducts at the rear of the range. Do not block these ducts when cooking in the oven—it is important that the flow of hot air from the oven and fresh air to the oven burner be uninterrupted. Avoid touching the vent openings or nearby surfaces during oven or broiler operation—they may become hot.

■Handles of pots and pans on the cooktop may become hot if left too close to the vent.

■Do not leave plastic or flammable items on the cooktop—they may melt or ignite if left too close to the vent.

■Do not leave closed containers on the cooktop. The pressure in closed containers may increase, which may cause them to burst.

■Metal items will become very hot if they are left on the cooktop, and could cause burns.

Troubleshooting Tips

Power Outage

CAUTION: Do not make any attempt to operate the electric ignition oven during an electrical power failure.

The oven or broiler cannot be lit during a power failure. Gas will not flow unless the glow bar is hot.

If the oven is in use when a power failure occurs, the oven burner shuts off and cannot be re-lit until power is restored. This is because the flow of gas is automatically stopped and will not resume when power is restored until the glow bar has reached operating temperature.

Consumer Support

Oven Light

Touch the OVEN LIGHT pad on the upper control panel to turn the light on or off.

On some models, the OVEN LIGHT switch is on the lower front control panel.

12