OVEN CONTROL, CLOCK AND TIMER
Clock To Set the Clock
The clock must be set for the automatic oven timing
functions to work properly. The time of day cannot be
changed during a Timed Baking or Self-Cleaning cycle.
1. Press the CLOCK pad.
2. Press the + or – pad to set the time of day.
3. Press the CLOCK pad to start.
CLOCK
CLOCK
Timer To Set the Timer
The timer is a minute timer;
it does not control oven operations.
The maximum setting on the timer
is 9 hours and 55 minutes.
1. Press the TIMER
ON/OFF pad.
2. Press the + or –
pad to set the
amount of time
on the timer.
The timer will start automatically
within a few seconds of releasing
the pad. The timer, as you are
setting it, will display seconds until
1 minute is reached. Then it will
display minutes and seconds until
60 minutes is reached.
After 60 minutes, it will display
hours (“HR” now appears in
display) and minutes until the
maximum time of 9 hours and
55 minutes is reached.
–+
TIMER
ON/OFF
To Reset the Timer To Cancel the Timer
If “TIMER” is displayed, press the + or – pad until
desired time is reached.
If “TIMER” is not displayed, press the TIMER
ON/OFF pad first, then follow the instructions above
to set the timer.
Press and hold the TIMER ON/OFF pad until the
word “TIMER” disappears from the display.
End of Cycle Tone Display Messages
The end of cycle tone is a series of three beeps
followed by one beep every six seconds. If you would
like to remove the signal that beeps every six seconds,
press and hold the CLEAR/OFF pad for 10 seconds.
To return the signal that beeps every six seconds,
press and hold the CLEAR/OFF pad for 10 seconds.
If “door” appears in the display, the door is open.
Close the door. If “LOCK” appears in the display, the
oven door is in the locked position. Bake, Broil and
Cook Time cannot be set if the door is in the locked
position.
Power Outage
After a power outage, when power is restored, the
display will flash and time shown will no longer be
correct—for example, after a 5-minute power
interruption the clock will be 5 minutes slow.
All other functions that were in operation when the
power went out will have to be programmed again.
12