43
2. Locate the outside edge of the device 5.4 cm
(21⁄8″) toward the center of the range from the
marked edge of the range.
3. Using the device as a template, mark the
position of the hole for the screw.
4. For wood construction, drill a pilot hole at an
angle of 20 degrees from the horizontal. A nail
or awl may be used if a drill is not available.
Mount the Anti-Tip device with the screw
provided.
For cement or concrete construction, you will
need a 6 mm x 3.8 cm (1/4″x 11⁄2″) lag bolt and a
1.3 cm (1/2″) O.D. sleeve anchor, which are not
provided. Drill the recommended size hole for
the hardware.
Install the sleeve anchor into the drilled hole
and then install the lag bolt through the device.
The bolts must be properly tightened as
recommended for the hardware.
5. Slide the range against the wall, and check
for proper installation by grasping the front edge
of the cooktop and carefully attempting to tilt the
range forward.
WHEN ALL HOOKUPS ARE COMPLETED: MAKE SURE ALL CONTROLS ARE LEFT IN THEOFF POSITION. MAKE SURE THE FLOW OF COMBUSTION ANDVENTILATION AIR TO THE RANGE IS UNOBSTRUCTED.INSTALLING THE ANTI-TIP DEVICE
1. Mark the wall where the RIGHT EDGE of the
range is to be located. Be sure to allow for the
countertop overhang if you intend to install the
range next to cabinets.
WARNING:
• Range MUST be secured with an
approved Anti-Tip device.
• Unless properly installed, the range could
be tipped by you or a child standing, sitting
or leaning on an open door.
• After installing the Anti-Tip device, verify
that it is in place by carefully attempting to
tilt the range forward.
• This range has been designed to meet all
recognized industry tip standards for all
normal conditions.
• The use of this device does not preclude
tipping of the range when not properly
installed.
• If the Anti-Tip device supplied with the
range does not fit this application, use the
universal Anti-Tip device WB02X7909.
9LEVELING THE RANGE
1. Remove the storage
drawer or kick panel.
2. Use a 5 mm (3/16″)
open-end or socket
wrench to back out both
rear leveling legs
approximately two turns.
3. Use a 3.5 cm (13⁄8″)
open-end or adjustable
wrench to back out the
front leveling legs two
turns.
4. Install the oven
shelves in the oven and position the range
where it will be installed.
5. Check for levelness by placing a spirit level or
a cup, partially filled with water, on one of the
oven racks. If using a spirit level, take two
readings—with the level placed diagonally first
in one direction and then the other.
6. Adjust the leveling legs until the range is level.
7. After the range is level, slide the range
away from the wall so that the Anti-Tip device
can be installed.
8
Marked Edge
of Range
Approx. 20°
Slotted
Head
Screw
Anti-Tip
Device
Wallplate
5.4 cm
(21⁄8″)
Wood Screw
Wallplate
Anti-Tip
Device
Back of
Range
Wallboard