53
Installation Instructions
INSTALLING THE ANTI-TIPDEVICE

10

A. Mark the wall where the RIGHT EDGE of the range
is to be located. Be sure to allow for the countertop
overhang if you intend to install the range next to
cabinets.
B. Locate the outside edge of the device 21⁄8″toward the
center of the range from the marked edge of the
range.
C. Using the device as a template, mark the position of
the hole for the screw.
D. For wood construction, drill a pilot hole at an angle
of 20 degrees from the horizontal. A nail or awl may
be used if a drill is not available.
Mount the Anti-Tip device with the screw provided.
For cement or concrete construction, you will need
a 1/4″x 11⁄2″lag bolt and a 1/2″O.D. sleeve anchor,
which are not provided. Drill the recommended size
hole for the hardware.
WARNING!
■Range must be secured with an approved Anti-
Tip device.
■Unless properly installed, the range could be
tipped by you or a child standing, sitting or
leaning on an open door.
■After installing the Anti-Tip device, verify that it
is in place by carefully attempting to tilt the
range forward.
■This range has been designed to meet all
recognized industry tip standards for all normal
conditions.
■The use of this device does not preclude tipping
of the range when not properly installed.
■If the Anti-Tip device supplied with the range
does not fit this application, use the universal
Anti-Tip device WB2X7909.
Anti-Tip
device
Slotted head
screw Wallplate
Approx. 20°
21⁄8”Marked edge of range
INSTALLING THE ANTI-TIPDEVICE
(CONT.)
Install the sleeve anchor into the drilled hole and then
install the lag bolt through the device. The bolts must
be properly tightened as recommended for the
hardware.
E. Slide the range against the wall, and check for
proper installation by grasping the front edge of the
cooktop and carefully attempting to tilt the range
forward.
Back of range
Wallboard
Wood screw
Anti-Tip
device
WHEN ALL HOOKUPS ARECOMPLETED
Make sure all controls are left in the off position. Make
sure the flow of combustion and ventilation air to the
range is unobstructed.
CONVERTING TO LP GAS

(or

converting back to natural gas from LP)

This range leaves the factory set for use with natural
gas. If you want to convert to LP gas, the conversion
must be performed by a qualified LP gas installer.
The conversion instructions and LP orifices can be
found attached to the range next to the pressure
regulator.
Keep these instructions and the orifices in case you
want to convert back to natural gas.

10