GE JGSP28 Before you call for service…, then “linE” with a, loud tone, Control signals after

Consumer Support Troubleshooting Tips Care and Cleaning Operating Instructions Safety Instructions

Before you call for service…

Troubleshooting Tips

Problem	Possible Causes	What To Do
Display flashes “bAd”	The installed connection	• Contact installer or electrician to correct miswire.
then “linE” with a	from the house to the unit
loud tone	is miswired.
Control signals after	You forgot to enter a	• Touch the BAKE pad and desired temperature or
entering cooking time	bake temperature or	the SELF CLEAN pad and desired clean time.
or delay start	cleaning time.
Display goes blank	A fuse in your home may	• Replace the fuse or reset the circuit breaker.
	be blown or the circuit
	breaker tripped.
	The clock is in	• See the Using the clock and timer section.
	black-out mode.
Display flashes	Power failure.	• Reset the clock.
Unable to get the	Oven control pads were	• The BROIL HI/LO and BAKE pads must be touched at
display to show “SF”	not touched properly.	the same time and held for 3 seconds.
Power outage,	Power outage or surge.	• Reset the clock. If the oven was in use, you must reset
clock flashes		it by touching the CLEAR/OFF pad, setting the clock
		and resetting any cooking function.
“Burning” or “oily”	This is normal in a new oven	• To speed the process, set a self-clean cycle for a
odor emitting from	and will disappear in time.	minimum of 3 hours. See the Using the self-cleaning
the vent		oven section.
Strong odor	An odor from the insulation	• This is temporary.
	around the inside of the oven
	is normal for the first few
	times the oven is used.
Fan noise	A cooling fan may	• This is normal. The cooling fan will turn off and on
	automatically turn	to cool internal parts. It may run after the oven is
	on and off.	turned OFF.

30