GE JGSP28 Burner Grates, Vent Grille and Vent Grille Cap, Oven Light Bulbs on some models, Center

www.GEAppliances.com

Safety

Vent grille	Vent grille
cap

Burner Grates, Vent Grille and Vent Grille Cap

Air inlet

Porcelain enamel burner grates, vent grille and vent grille cap should be washed regularly and, of course, after spillovers.

Wash them in hot, soapy water and rinse with clean water. You may also use abrasive cleaners and scouring pads, if needed. Dry them with a cloth—don’t put them back on the cooktop wet.

Although they’re durable, the grates, vent grille and vent grille cap will gradually lose their shine, regardless of the best care you can give them. This is due to their continual exposure to high temperatures.

Do not operate a burner for an extended period of time without cookware on the grate. The finish on the grate may chip without cookware to absorb the heat.

After cleaning, first replace the vent grille and the vent grille cap.

Replace the side grates so that they fit over the tabs on the vent grille. Make sure the grates are positioned securely over the burners and that they are stable and level.

Rubber Grate Feet

For stability, your cooktop has rubber feet on the burner grates. If any of these rubber feet should become damaged or lost, replace them immediately.

To order replacement rubber grate feet, please call our toll-free number:

National Parts

Center . . . . . . . . . . . . . . . . . . .800.626.2002

Rubber Grate Feet . . . . . . .#WB02T10101

Socket

Receptacle

Bulb

Tab

Glass cover

Oven Light Bulbs (on some models)

NOTE: The glass cover should be removed only when cold. Wearing latex gloves may offer a better grip.

CAUTION: Before replacing your oven light bulb, disconnect the electrical power to the oven at the main fuse or circuit breaker panel.

Be sure to let the light cover and bulb cool completely.

For your safety, do not touch a hot bulb with bare hands or a damp cloth.

To remove:

Turn the glass cover counterclockwise 1/4 turn until the tabs of the glass cover clear the grooves of the socket.

Using gloves or a dry cloth, remove the bulb by pulling it straight out.

To replace:

Use a new 130-volt halogen bulb, not to exceed 50 watts.

Using gloves or a dry cloth, remove the bulb from its packaging. Do not touch the bulb with bare fingers.

Receptacle

Use gloves or cloth

Push the bulb straight into the receptacle all the way.

Place the tabs of the glass cover into the grooves of the socket. Turn the glass cover clockwise 1/4 turn to engage.

For improved lighting inside the oven, clean the glass cover frequently using a wet cloth. This should be done when the oven is completely cool.

Reconnect electrical power to the oven.

23

Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer Support