www.GEAppliances.com
Safety
Grid
Pan
Broiler Pan and Grid
After broiling, remove the broiler pan from the oven. Remove the grid from the pan. Carefully pour out grease from the pan into a proper container. Wash and rinse the broiler pan and grid in hot water with a
If food has burned on, sprinkle the grid with detergent while hot and cover with wet paper towels or a dishcloth. Soaking the pan will remove
The broiler pan and grid may be cleaned with a commercial oven cleaner.
Both the broiler pan and grid can also be cleaned in a dishwasher.
Do not store a soiled broiler pan and grid anywhere in the range.
CAUTION: Do not clean the broiler pan or grid in a
Instructions Operating
Removable Broiler Drawer (on some models)
To remove:
When the broiler is cool, remove the grid and pan.
Pull the broiler drawer out until it stops, then push it back in about one inch.
Grasp the handle, lift and pull the broiler drawer out. Clean the broiler drawer with hot soapy water.
To replace:
Hold the broiler drawer in the raised position as you slide it partway into the range. Then lower the drawer and push it completely closed.
Oven Air Vents
Never block the vents (air openings) of the | Air openings are located at the rear of |
range. They provide the air inlet and outlet | the cooktop, at the top and bottom of the |
that are necessary for the range to operate | oven door, and at the bottom of the range, |
properly with correct combustion. | under the kick panel or broiler drawer |
Vent appearance and location vary. | (depending on the model). |
Lower Control Panel (Front Manifold Panel) and Knobs
Pull the knob straight off the stem.
It’s a good idea to wipe the control panel after each use of the oven. Use a damp cloth to clean or rinse. For cleaning, use mild soap and water or a 50/50 solution of vinegar and water. For rinsing, use clean water. Polish dry with a soft cloth.
Do not use abrasive cleansers, strong liquid cleaners, plastic scouring pads or oven cleaners on the control panel— they will damage the finish.
Do not bend knobs by pulling them up or down or by hanging a towel or other such loads. This can damage the gas valve shaft.
The control knobs may be removed for easier cleaning. To remove a knob, pull it straight off the stem. If knob is difficult to remove, place a towel or dishcloth between the knob and control panel and pull gently. Wash the knobs in soap and water or a vinegar and hot water solution.
Metal parts can be cleaned with soap and water. Do not use steel wool, abrasives, ammonia, acids or commercial oven cleaners. Dry with a soft cloth.
Instructions Installation Instructions Troubleshooting Tips Consumer Support
21
