GE JGBS07 In The Commonwealth Of Massachusetts, Before You Begin, Installation Instructions

Installation Instructions

Range

If you have questions, call 800.GE.CARES or visit our Website at: www.GEAppliances.com

IN THE COMMONWEALTH OF MASSACHUSETTS

•This product must be installed by a licensed plumber or gas fitter.

•When using ball-type gas shut-off valves, they shall be the T-handle type.

•A flexible gas connector, when used, must not exceed 3 feet.

BEFORE YOU BEGIN

Read these instructions completely and carefully.

Installation of this range must conform with local codes, or in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1/NFPA.54, latest edition. In Canada, installation must conform with the current Natural Gas Installation Code, CAN/CGA- B149.1 or the current Propane Installation Code, CAN/CGA-B149.2, and with local codes where applicable. This range has been design-certified by CSA International according to ANSI Z21.1, latest edition and Canadian Gas Association according to CAN/CGA-1.1 latest edition.

As with any appliance using gas and generating heat, there are certain safety precautions you should follow. You will find these precautions in the Important Safety Information section in the front of this manual. Read them carefully.

•IMPORTANT — Save these

instructions for local inspector’s use.

•IMPORTANT — Observe all governing codes and ordinances.

•Note to Installer – Be sure to leave these instructions with the Consumer.

•Note to Consumer – Keep these instructions for future reference.

•Note – This appliance must be properly grounded.

•Servicer – The electrical diagram is in an envelope attached to the back of the range.

•Skill Level – Installation of this appliance requires basic mechanical skills.

•Proper installation is the responsibility of the installer.

•Product failure due to improper installation is not covered under the Warranty.

24