GE JKD915 Provide Cabinet Support, Install Anti-TipBrace, Cleaning Operating Instructions

Safety Instructions

Installation of the warming drawer.

Read these instructions completely and carefully.

Provide Cabinet Support

Cleaning Operating Instructions

231⁄2″

2″ x 4″ or equivalent runners

22″

27″

231⁄2″

2″ x 4″ or equivalent runners

25″

30″

Installation Instructions Care and

IMPORTANT: When installed below a single or double oven, check to be sure that any oven supports above the cutout do not obstruct the 231⁄2″ required depth of the warming drawer cutout.

■A 2″ minimum clearance between oven and warming drawer cutouts are required. Additional clearance may be required if

2 x 4 blocks are used to support runners or solid floor of the oven above.

■The warming drawer may be supported by either a solid bottom, 2 x 4 or 2 x 2 runners.

■The support must be level and rigidly mounted, flush with the bottom edge of the cutout.

■There is no way to level the drawer once it has been installed. Be sure supports are level.

■The entire weight of the drawer is supported by the runners or solid floor and must be capable of supporting 150 lbs.

Step 1—Install Anti-Tip Brace

Troubleshooting Tips

WARNING: ANTI-TIP PRECAUTIONS:

The anti-tip brace must be installed to prevent the drawer from tipping forward when opened and loaded.

Failure to do so could result in personal injury.

Install 2x4 or 2x2 anti-tip brace against rear cabinet wall 9″ from floor to bottom of brace

9″

Consumer Support

2x4 or 2x2 runners

or solid bottom

14