Tips Customer Service, Operating Instructions, 31⁄2”

Stainless Steel Surfaces (on some models)

Safety Instructions

Do not use a steel-wool pad; it will scratch the surface.

To clean the stainless-steel surface, use a hot, damp cloth with a mild detergent suitable for stainless-steel surfaces. Use a clean, hot, damp cloth to remove soap. Dry with a dry, clean cloth.

If food soil remains, try a general kitchen cleaner, such as Fantastik®, Simple Green®, or Formula 409®.

For hard-to-clean soil, use a standard stainless-steel cleaner, such as Bon-Ami® or Cameo®.

Apply cleaner with a damp sponge. Use a clean, hot, damp cloth to remove cleaner. Dry with a dry, clean cloth. Always scrub lightly in the direction of the grain.

After cleaning, use a stainless-steel polish, such as Stainless Steel Magic®, Revere Copper and Stainless Steel Cleaner®, or Wenol All Purpose Metal Polish®. Follow the product instructions for cleaning the stainless-steel surface.

Operating Instructions

Oven Light Bulb (on some models)

Socket

31⁄2”

Maximum length

Bulb

Tab

Glass cover

NOTE: The glass cover (on some models) should be removed only when cold. Wearing latex gloves may offer a better grip.

Before replacing the bulb, disconnect electrical power to the oven at the main fuse or circuit breaker panel. Let the bulb cool completely before removing it. For your safety, do not touch a hot bulb with a damp cloth. If you do, the bulb will break.

To remove:

Turn the glass cover counterclockwise 1/4 turn until the tabs of the glass cover clear the grooves of the socket. Remove the bulb.

To replace:

Put in a new 40-watt appliance bulb. Place the tabs of the glass cover into the grooves of the socket. Turn the glass cover clockwise 1/4 turn.

NOTE:

■A 40-watt appliance bulb is smaller than a standard 40-watt household bulb.

■Install and tighten the cover clockwise.■Reconnect electrical power to the oven.

■For improved lighting inside the oven, clean the glass cover frequently using a wet cloth. This should be done when the oven is completely cool.

Care and Cleaning Troubleshooting

	Oven Light Bulb (on some models)
	CAUTION: Before replacing your oven light bulb,
	disconnect the electrical power to the oven at the
	main fuse or circuit breaker panel.
	Be sure to let the light cover and bulb
	cool completely.
	To remove the cover:
Wire cover holder	Hold a hand under the cover so it
	doesn’t fall when released. With
	fingers of the same hand, firmly
	push back the wire cover holder.
	Lift off the cover.
	Do not remove any screws to remove the cover.

To replace the cover:

Place it into grooves of the light receptacle. Pull wire forward to the center of the cover until it snaps into place.

Connect electrical power to the oven.