Using the clock and timer. | www.GEAppliances.com |
Safety
Make sure the clock is set to the correct time of day.
To Set the Clock
The clock must be set to the correct time of day for the automatic oven timing functions to work properly. The time of day cannot be changed during a timed baking or
Press the CLOCK pad.
Press the HOUR and MIN + or
–pads to set the time of day. Press the START pad.
Instructions Operating
The timer is a minute timer only.
The timer does not control oven operations. The maximum setting on the timer is 9 hours and 59 minutes.
To Set the Timer
Press the KITCHEN TIMER
ON/OFF pad.
Press the HOUR and MIN + or
–pads until the amount of time you want shows in the display.
If you make a mistake, press KITCHEN TIMER ON/OFF and begin again.
Press the START pad.
When the timer reaches :00, the control will beep 3 times followed by one beep every 6 seconds until the KITCHEN TIMER ON/OFF pad is pressed.
The 6 second tone can be canceled by following the steps in the Special features of your oven control section under Tones at the End of a Timed Cycle.
Instructions Care
After pressing the START pad, SET disappears; this tells you the time is counting down, although the display does not change until one minute has passed.
and Cleaning
To Reset the Timer
If the display is still showing the time remaining, you may change it by pressing the KITCHEN TIMER ON/OFF pad, then press the HOUR and MIN + or – pads until the time you want appears in the display.
If the remaining time is not in the display (clock, delay start or cooking time are in the display), recall the remaining time by pressing the KITCHEN TIMER ON/OFF pad and then pressing the HOUR and MIN + or – pads to enter the new time you want.
Troubleshooting
To Cancel the Timer
Press the KITCHEN TIMER ON/OFF pad twice.
13
