GE JTD910SBSS Provide Cabinet Support, Install Anti-Tip Brace, Operating Instructions Care and

Read these instructions completely and carefully.

Provide Cabinet Support

Safety Instructions

231⁄2″

2″ x 4″ or equivalent runners

22″

27″

231⁄2″

2″ x 4″ or equivalent runners

25″

30″

Operating Instructions Care and

IMPORTANT: When installed below a single or double oven, check to be sure that any oven supports above the cutout do not obstruct the 231⁄2″ required depth of the warming drawer cutout.

■A 2″ minimum clearance between oven and warming drawer cutouts are required. Additional clearance may be required if

2 x 4 blocks are used to support runners or solid floor of the oven above.

■The warming drawer may be supported by either a solid bottom, 2 x 4 or 2 x 2 runners.

■The support must be level and rigidly mounted, flush with the bottom edge of the cutout.

■There is no way to level the drawer once it has been installed. Be sure supports are level.

■The entire weight of the drawer is supported by the runners or solid floor and must be capable of supporting 150 lbs.

Cleaning Installation Instructions

Step 1—Install Anti-Tip Brace

WARNING: ANTI-TIP PRECAUTIONS:			Install 2x4 or 2x2 anti-tip brace
The anti-tip brace must be installed to prevent			against rear cabinet wall 9″
			from floor to bottom of brace
the drawer from tipping forward when opened
and loaded.
Failure to do so could result in personal injury.
		9″
	2x4 or 2x2 runners
	or solid bottom

15

Troubleshooting Tips Customer Service