GE JTP20 installation instructions Installation

Installation	30” Built-In Wall Oven
Instructions	JTP20, JTP25, JTP28, JTP48, JTP50, JT912,
	JT915, JT952, JT955, ZET938, ZET958

If you have questions, call 1.800.GE.CARES or visit our website at: ge.com

Before You Begin	• Proper installation is the responsibility
	of the installer and product failure due
Read these instructions carefully and completely.	to improper installation is NOT covered
• IMPORTANT—Save these	under warranty.
	• NOTE—This appliance must be properly
instructions for local inspector’s use.
	grounded.
• IMPORTANT—Observe all
	• ATTENTION INSTALLER
governing codes and ordinances.
• Note to Installer—Be sure to leave these	All electric wall ovens must be hard wired
instructions with the consumer.	(direct wired) into an approved junction
• Note to Consumer—Keep these	box. A plug and receptacle is NOT permitted
	on these products.
instructions for future reference.

Parts Included

Metal

Bottom Trim

Screws For	Plastic
Installation
	Bottom Trim

Optional Metal Bottom Trim Assembly (on some models)

Materials Needed

Wire Nuts

Strain Relief Clamp	Junction
for 1/2” conduit	Box

36” of String

Tools Needed

1/8” Drill Bit and	Phillips
Electric or Hand Drill	Screwdriver

31-10659	1-07 JR
	1