GE JV247, JV248 8FOR 31⁄4″ X 10″ RECTANGULAR, ONLY:, 9FOR 7″ ROUND VERTICAL DUCTED, DISCHARGE INSTALLATIONS ONLY:, 10FOR RECESSED-BOTTOMCABINETS, ONLY

Installation Instructions

8FOR 31⁄4″ X 10″ RECTANGULAR

DUCTED DISCHARGE INSTALLATIONS

ONLY:

Attach exhaust adaptor/damper over the appropriate knockout opening (for vertical or horizontal, depending on installation) with two exhaust adaptor screws. Make sure damper pivot is nearest to top/back edge of hood. Remove tape from damper flap.

Exhaust adaptor/damper
(vertical discharge position)	Tape

Pivot	Top/back edge
(depending on
installation)	Exhaust adaptor/damper
	(horizontal discharge position)

9FOR 7″ ROUND VERTICAL DUCTED

DISCHARGE INSTALLATIONS ONLY:

Bend up the duct alignment ears in preparation for later attachment of the 7″ duct.

Attachment ear tabs

10FOR RECESSED-BOTTOM CABINETS

ONLY

Wood shims

(minimum thickness 3/8″)

•If the cabinets have front, side or back trim, make 2 wood shims a minimum of 3/8″ thick and cut to fit the width of the inner recessed cabinet bottom. Attach them to the cabinet bottom recess on both sides. See Step 11 for marking locations.

11