Connect Power
Plug power cord into a properly grounded receptacle.
Safety Instructions
Installing the Cooktop
■With the Downdraft in the “Down” position, place the cooktop into the cutout.
■Push the cooktop back until the back edge of the cooktop just barely touches the front edge of the downdraft cover.
■Using a dime as a thickness gauge, align the cooktop so that there is a minimum uniform gap of 0.05″ (the thickness of a dime) between the cooktop and the downdraft cover.
NOTE: Do not force the downdraft cover to move rearward when aligning the cooktop. This may cause the downdraft cover to impact and damage the cooktop when the vent is raised and lowered.
NOTES:
■Accurate alignment of cooktop and downdraft is necessary to ensure that there is no interference when air vent is raised and lowered. There should be a gap of 0.05″ (the thickness of a dime) between the back edge of the cooktop and the front edge of the downdraft cover.
■Radiant cooktops cannot be flush mounted when using this downdraft vent.
Operating Instructions
Optional Kits
JXRB57 optional accessory for indoor remote | JXBC57 optional outdoor cover accessory for |
location of the blower/motor assembly. Use this | remote installation of blower and motor assembly |
kit when the blower and motor assembly will be | on an outside wall. |
located outside or below the cabinet floor. |
|
17
Installation Instructions Troubleshooting Tips Consumer Support