GE JVB93 Tools You Will Need, Before Starting Installation, Check the Following Requirements, Take Measurements

Tools You Will Need
5
INSTALLATION INSTRUCTIONS
Before Starting Installation,
Check the Following
Requirements
This downdraft blower system is designed to
be used to exhaust smoke and odors when
cooking with all GE electric and sealed burner
gas cooktops (not approved for standard
burner gas cooktops). It can be mounted in
either an island or peninsula location.
Requirements for an approved
installation
• 26″minimum cabinet depth
• 26″minimum from the back of the
downdraft to the front of the countertop
• 231⁄2″ minimum FLAT countertop surface
NOTE: JGP932S, JP350SC, JP930SC and
JP938SC require 235⁄8″ flat surface area.
• Plan the placement of the electrical outlet box
carefully. It should NOT be installed on the back
wall of the cabinet because it may interfere with
the downdraft. It should be installed on a side
wall or adjacent cabinet. Make sure it is within
reach of the unit’s 2-ft. long power cord and
conforms to all local codes.
Install a standard wiring box with a 3-pronged
outlet.
• Plan the location of the gas supply pipe (for
gas cooktops) carefully to avoid interference
with the downdraft installation.
Specifications
This unit can be easily installed following these
basic steps:
• Cut out the countertop opening.
• Install the downdraft in the cabinet.
• Connect the ductwork and electrical.
• Install the cooktop.
Take Measurements
Refer to the cooktop installation instructions for
dimensions of cooktop, countertop cut-out, and
cabinet requirements.
•The 30″models will fit in most 30″wide
cabinets and the 36″models will fit in most 36″
wide cabinets.
• To install a cooktop with this downdraft, the
cabinet depth must be 26″minimum.
A countertop with a raised lip may not allow
enough flat countertop for a proper installation.
Before starting installation, review the following
pages carefully.
Cutout dimension and illustrations are given for
30″and 36″cooktops.
Flat counter
area
26″
Minimum 26″
Cabinet depth required
(continued next page)
Flat blade and Phillips
screwdrivers
Pencil
Duct tape Saw (saber or keyhole)
(OR other depending upon material)
Electric Drill Metal Snips
(in some applications)
1/4″Through 7/16″
Pivoting Hex Socket Pliers
Tape measure Wire stripper
Flashlight Caulking
Level 1/4″Through 7/16″
Nut Driver
VOLTS AMPS CFM DUCT
120 4.0 500 31⁄4X 10