GE JVM132J Light Bulb Replacement, Cooktop Light Oven Light, Circuit breaker panel or pull plug

Light Bulb Replacement

Cooktop Light Oven Light

GROUNDING INSTRUCTIONS

REMOVE SCREW

To replace cooktop light, first disconnect power at main fuse or

circuit breaker panel or pull plug.

Remove screw on right side of light compartment cover and lower cover until it stops.

To replace your oven light, first disconnect power at main fuse or circuit breaker panel or pull plug. Remove the top grill by taking out the 2 screws that hold it in place.

This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. This appliance is equipped with a power cord having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded. (Fig. 1 )

WARNING–impro~er

use of the grounding plug ~an result in a risk of electric shock.

PREFERRED METHOD

1 1

Be sure bulbs to be replaced are cool before removing. Break the adhesive seal by gently unscrewing the bulbs. Replace with 40-watt incandescent bulbs (WB02X4253) available from your GE supplier. High intensity 40-watt bulbs

(40S 11 N/l ), which are available in supermarkets and hardware stores, may also be used for replacements. Raise light compartment cover and replace screw. Connect electrical power to microwave oven.

Next, remove the single screw located above door near center of oven that secures light housing. Replace burned-out bulb with a 30-watt incandescent bulb (WB02X4235), available from your GE supplier.

Clean off the grease and dust on hood surfaces ~) ften. Use a solution of warm water and detergent. About 1 tablespoon of ammonia may be added to the water. Take care not to touch the filters and enamel surfaces with this solution; ammonia will darken metal.

,.

Ensure proper ground

Fig. 1 exists before use

Consult a qualified electrician or service technician if the grounding instructions are not completely understood, or if doubt exists as to whether the appliance is properly grounded.

Where a standard two-prong wall receptacle is encountered, it is your personal responsibility and obligation to have it replaced with

aproperly grounded three-prong wall receptacle.

Do not under any circumstance cut or remove the third (ground) prong from the power cord.

Do not use an adapter plug with this appliance.

Do not use an extension cord with this appliance.

28