GE JVM1631WJ GE Appliances, Duct, Equivalent Feet, Transition Adaptor, B. Wall Cap, C. 90 Elbow

Models: JVM1631WJ JVM1631CJ JVM1631BJ

1 3
Download 3 pages 43.53 Kb
Page 2
Image 2
Optional Accessories (Available at additional cost)

GE Appliances

JVM1631BJ/CJ/WJ – GE Spacemaker® Over-the-Range Microwave Oven with Recirculating Venting

Optional Accessories (Available at additional cost)

12" Filler Panel Kits

JX41–Black

JX40WH–White

15" Filler Panel Kits

JX48BL–Black

JX48WH–White

When replacing a 36" or 42" range hood, this kit fills in the additional width to provide a custom built-in appearance. For installation between cabinets only; not for end-of-cabinet installation. Each kit contains two 3"-wide filler panels.

Filter Kits

JX81D–Recirculating Charcoal Filter Kit (included with non-vented models)

To be used when the Spacemaker microwave oven cannot be vented to the outside.

HOOD EXHAUST DUCT

Outside ventilation requires a HOOD EXHAUST DUCT. Read the following carefully.

EXHAUST CONNECTION: The hood exhaust has been designed to mate with a standard 3-1/4" x 10" rectangular duct.If a round duct is required, a rectangular-to-round transition adaptor must be used. Do not use less than a 6" diameter duct

REAR EXHAUST: If a rear or horizontal exhaust is to be used, care should be taken to align exhaust with space between studs, or wall should be prepared at the time it is constructed by leaving enough space between the wall studs to accommodate exhaust.

MAXIMUM DUCT LENGTH: For satisfactory air movement, the total duct length of 3-1/4" x 10" rectangular or 6" diameter round duct should not exceed 140 equivalent feet.

ELBOWS, TRANSITIONS,WALL AND ROOF CAPS, etc., present additional resistance to airflow and are equivalent to a section of straight duct which is longer than their actual physical size. When calculating the total duct length, add the equivalent length of all transitions and adaptors plus the lengths of all straight duct sections. The chart below shows the approximate feet of equivalent length of some typical ducts.

Duct

Equivalent Feet

A. Rectangular-To-round5 ft.
Transition Adaptor

 

B. Wall Cap

40 ft.

 

 

C. 90° Elbow

10 ft.

 

 

D. 45° Elbow

5 ft.

 

 

E. 90° Elbow

25 ft.

 

 

F. 45° Elbow

5 ft.

 

 

G. Roof Cap

24 ft.

 

 

Specification Created 10/03

Listed by

Underwriters

RLaboratories

For answers to your Monogram,® GE Profileor GE® appliance questions, visit our website at GEAppliances.com or call

GE Answer Center® service, 800.626.2000.

340111

Page 2
Image 2
GE JVM1631WJ GE Appliances, Duct, Equivalent Feet, Optional Accessories Available at additional cost, Transition Adaptor