GE JVM290WV, JVM290AV Light Bulb Replacement, The Exhaust Feature, Cooktop Light, Oven Light

LIGHT BULB REPLACEMENT

Cooktop Light

To replace the
combination
cooktop light/
night light, first
disconnect
power at main
fuse or circuit	REMOVE SCREW
breaker panel
or pull plug.

Remove screw on right side of light compartment cover and lower cover until it stops.

Be sure bulbs to be

replaced are cool before removing. Break the adhesive seal by gently unscrewing the bulbs.

Replace with 40-watt

incandescent bulbs (WB02X4253) available from your GE supplier. High intensity 40-watt bulbs (40S11N/1), which are available in supermarkets and hardware stores, may also be used for replacements. Raise light compartment cover and replace screw. Connect electrical power to microwave oven.

The Exhaust Feature

Oven Light

To replace your oven light, first disconnect power at main fuse or circuit breaker panel or pull plug. Remove the top grill by taking out the 2 screws that hold it in place.

Next, remove the single screw located above door near center of oven that secures light housing. Replace burned-out bulb with

a 40-watt incandescent bulb (WB02X4253), available from your GE supplier.

Clean off the grease and dust on hood surfaces often. Use a solution of warm water and detergent. About 1 tablespoon of ammonia may be added to the water. Take care not to touch the filters and enamel surfaces with this solution; ammonia will darken metal.

Grounding Instructions

Light Bulb Replacement

33