GE LISR310 operating instructions Cleaning Fabric Softener Dispenser

Fabric Softener

Dispenser

Pour liquid fabric softener and water into fabric softener dispenser

This dispenser automatically releases liquid fabric softener at the proper time during the cycle. To use, follow these steps:

1Make sure dispenser is securely attached to agitator.

2Pour liquid fabric softener into dispenser, using amount recommended on package.

3Add water to dispenser until it reaches the maximum fill line.

NOTE:

•Do not stop the washer during the first spin. This will cause the dispenser to empty too soon.

•Do not use the Fabric Softener Dispenser with the Auto Soak.

•Never pour fabric softener directly on clothes. It will leave spots on clothes.

•Only use dispenser for liquid fabric softeners. If dispenser gets clogged, see Cleaning section below.

Do not pour anything into the agitator if the top is removed

Cleaning Fabric Softener Dispenser

Separate for cleaning

1Remove the dispenser from the top of the agitator.

2Separate the dispenser cup from the cover by grasping the top and pushing down on the inside of the cup with your fingers. Dispenser cup will pop free from the cover.

3To clean dispenser, soak both the dispenser cup and the dispenser cover in a solution of warm water and liquid detergent.

4If necessary, loosen build-up with a clean, soft cloth after soaking. Do not use a stiff brush; you may roughen the surface of the dispenser.

5Rinse and reassemble dispenser. Place dispenser back on the agitator.

7