GE LISR310 operating instructions If Something Goes Wrong, Water Won’t Drain

If Something Goes Wrong

Problem	Possible Causes	What to Do
Washer Won’t Operate	Washer is unplugged	• Make sure cord is plugged securely into a
		working outlet.
	Water supply is turned off	• Turn both hot and cold taps fully on.
	Controls are not set properly	• Check controls and make sure Cycle knob
		is pulled out to an on position.
	Lid is open	• Close lid and pull Cycle knob out to an on
		position.
	Circuit breaker/fuse is	• Check house circuit breakers/fuses. Replace
	tripped/blown	fuses or reset breaker. Washer should have
		separate outlet.

Water Temperature is Incorrect

Control is not set properly	• Check water temperature control and adjust.
Water supply is turned off	• Turn both hot and cold taps fully on and
or improperly connected	make sure hoses are connected to correct
	taps.

Water valve screens are	• Turn off the water source and remove the
stopped up	water connection hoses from the upper back
	of the washer. Use a brush or toothpick to
	clean the screens in the machine. Reconnect
	the hoses and turn the water source back on.

House water heater is not set properly

•Make sure house water heater is delivering water at 48°C.–65°C. (120°F.–150°F.).

Water Won’t Drain

Drain hose is kinked or improperly connected

•Straighten drain hose and make sure washer is not sitting on it.

•Top of drain outlet should be less than 1m (3 ft.) above floor.

11