05-4558A01, Rev. C MDS Mercury Series Startup Guide
3
Step 1—Mount the TransceiverUse the supplied 6-32 x 1/4 inch (6 mm) screws to attach the mounting
brackets to the bottom of the radio. Figure 1 shows the mounting
dimensions of the unit. Mount the radio to a stable surface. (Fasteners
not normally supplied.)
Figure 1. Transceiver Mounting Dimensions
(Dimensions for AP and Remotes identical)
Use only the supplied mounting bracket screws. Screws
extending farther than 1/4 inch (6 mm) into the case
may cause internal PC board damage.
Step 2—Install the AntennaTo minimize RF interference, the antenna should be mounted at least
nine inches (> 23 cm) from the connected device(s), sensors and other
external components of the system. Additional information on antenna
selection and installation is provided in the
Mercury Reference
Manual
.
Install GPS Antenna
Install the GPS antenna in accordance with the manufacturer’s instruc-
tions, and connect the antenna cable to the SMB-type connector on the
transceiver’s front panel.
2.75˝ (7 cm)
8 5/8˝ (21.8 cm)
CAUTION
POSSIBLE
EQUIPMENT
DAMAGE