Using the Remote
Programming the Remote
The universal remote can be programmed to control most brands of remote controllable VCRs, receivers, etc. The remote is already programmed to control most RCA, GE and PROSCAN TVs, VCRs, Laserdisc players and Satellite Receivers.
Testing the Remote
To determine whether the universal remote needs to be programmed, turn a device on, such as a VCR, point the remote at the VCR, and press the VCR1 button. Then press POWER or CHAN (channel up) or CHAN (channel down) to see if the VCR responds to the remote commands. If not, the remote needs to be programmed.
Programming the Remote to Control a VCR, Laserdisc player, Satellite Receiver or Cable Box
Follow these steps to program your universal remote to control a VCR, Laserdisc player, Satellite Receiver or Cable Box:
1.Turn on the component to be programmed.
2.Look up the brand and code number(s) for the component on the code list on the last page of this section, Using the Remote.
3.Press and hold the button on the remote you want to program.
4.Enter the code from the code list.
5.Release button, and then press POWER to see if the component responds to the remote commands. If it doesn’t, try pressing the component button and then POWER again.
6.If you get no response, repeat these steps using the next code listed for your brand, until the component responds to the remote commands.
| VC | R1 | SAT |
|
| |
WER |
| •CA |
| |||
|
|
|
| BLE | TV | |
PO |
|
|
|
|
| |
| R | 2 |
|
|
| |
|
| •LD AU |
|
| ||
| VC |
|
| DIO |
| |
CHAN
VOLVOL
CHAN
1
2
3
4
5
6
7
8
9
0
You’ll use these buttons when you program the remote to control any device.
The remote may not operate all models of all brands.
Modes of Operation
Because this universal remote can control several different components (Laserdisc player, VCR, Cable Box, etc.), it uses operational modes triggered by the component buttons. For example, if you want the remote to control the TV, you would press the TV button to put the remote into TV mode before you could control the TV.
10
