Installation Instructions
STEP 8–POSITION WATER LINE
AND HOUSE WIRING
•Position water supply line and house wiring on the floor of the opening to avoid interference with base of dishwasher and components under dishwasher.
STEP 10–SLIDE DISHWASHER THREE-FOURTHS OF THE WAY INTO CABINET
DO NOT PUSH AGAINST FRONT PANEL WITH KNEES. DAMAGE WILL OCCUR.
• Slide dishwasher into the opening a few inches at a time.
�� �� | �� �� |
��
�� 
��
�����
�����������
����
Figure M
STEP 9–INSERT DRAIN HOSE
THROUGH CABINET
•Position dishwasher in front of cabinet opening. Insert drain hose into the hole in cabinet side. If a power cord is used, guide the end through a separate hole.
Maximum Drain
Hose Length 10'
Insulation
BlanketWater
Line
Drain Hose
House Wiring (If Power Cord is NOT Used)
Power Cord (If Used)
Figure N
Tip: Position water line and house wiring on the floor to avoid interference with base of dishwasher.
�������������������
���������������������
�������������������
������������������������
Figure O
•As you proceed, pull the drain hose through the opening under the sink. Stop pushing when the dishwasher extends about 6 inches forward of adjacent cabinets.
•Make sure drain hose is not kinked under the dishwasher and there is no interference with the water line and wiring or any other component.
STEP 11–INSTALL TRIM PIECES
Skip this step if trim is not supplied with the dishwasher.
•Locate the four trim pieces set aside in Step 1.
•Position the trim pieces so the lips face toward the dishwasher door.
•Select a long trim piece and press it onto the left side tub flange. Start with the top edge and press the trim piece completely onto the tub flange as you move towards the bottom. Repeat for the right side tub flange trim piece.
•Select one of the short trim pieces. Install it on the top tub flange to the left of the door latch. Select the remaining short piece of trim and install it on the top tub flange to the right of the door latch.
Trim Strip
Trim
Strip
Trim |
|
Strip | Top View |
Figure P
7
