Installation Instructions
STEP 4–REMOVE TOEKICK
• Remove the |
2 toekick screws |
Front of Dishwasher
and toekick.
Set aside for use in Step 21.
| �������� |
Figure I | ��������������� |
|
STEP 5–INSTALL POWER CORD
Skip this step if dishwasher will be direct wired or has a factory installed power cord.
•Wrap 90° elbow with thread seal tape.
•Thead 90° elbow into the water valve.
•Do not over tighten elbow; water valve bracket could bend or water valve fitting could break.
•Position the
end of the elbow to face the rear of the dishwasher.
90° Elbow
Figure K
Water
Valve
Bracket
Fill
Hose
Thread
Seal Tape
In this step you will need the junction box cover and the #10 x 1/2" hex head screw from the screw kit set aside in Step 1.
The power cord and connections must comply with the National Electrical Code, Section 422 and/or local codes and ordinances. Maximum power cord length is 6 feet. Power Cord Kit WX09X70910, available for purchase from an authorized GE Appliance Dealer, meets these requirements.
| Power Cord |
|
Junction Box | Wires |
|
|
| |
Cover |
|
|
|
| White |
| Ground | Black |
|
| |
|
| #10 |
White, Black and Green | Screw | |
| ||
Dishwasher Wires |
|
Figure J
•Install strain relief in junction box bracket.
•Insert power cord through strain relief and tighten.
•Make sure black, white and green dishwasher wires are threaded through small hole in junction box bracket.
•Connect power cord white (or ribbed) to dishwasher white wire, black (or smooth) to dishwasher black wire and ground to dishwasher green wire. Use UL listed wire nuts of appropriate size.
•Install junction box cover using #10 hex head screw. Be sure wires are not pinched under the cover.
STEP 7–INSTALL DRAIN HOSE TO DISHWASHER DRAIN PORT
Skip this step if drain hose has been pre-installed
In this step you will need the drain hose and clamp set aside in Step 1.
•Stand dishwasher upright.
•Place drain hose clamp over
Tip: Prevent drain hose damage and possible leaks. Be careful not to nick or cut the drain hose.
•Push the end of the drain hose over the drain pump outlet being careful not to disturb the check valve. Refer to Figure L.
•Seat the drain hose end against the hose stops on the pump outlet.
•Position hose clamp against the front lip of the drain hose and tighten clamp.
Note: Drain hose |
| Pump Outlet | Hose Stops |
|
|
| |
supplied with dish- |
|
|
|
washer is approxi- |
|
|
|
mately 78" long. If a |
|
|
|
longer hose is |
|
|
|
needed, a 120" long |
|
|
|
hose (10 feet) may |
|
|
|
be purchased from |
|
|
|
an authorized |
|
|
|
GE | Hose Clamp | Check Valve |
|
appliance | Do Not Remove |
| |
|
|
| |
dealer. The |
|
|
|
10' long |
|
|
|
hose is |
|
|
|
part |
|
|
|
number |
|
|
|
GPF10L |
|
|
|
Figure L
6