GE PDW9000, PDW8000 warranty Flashingdisplay lights, Recommended dishwasher products, Clean

_

D

ge.com

Start (continued)

PDW9000 Series

After selecting the cycle and desired enhancements, touch the START/RESETpad to ready the dishwasher to begin the cycle. Closethe door to start the cycle or begin the DELAVSTARTcountdown. When the cycle starts, the water fill begins and approximately 60 seconds later the wash action begins.

The dishwasher will always display your last selection and enhancements. If you don'twant to change the settings, simply touch the START/RESETpad to ready the dishwasher and closethe door to begin the cycle.

Also,if a power failure occurs NORMALand HEATEDDRYwill automatically be programmed. Hake any new selectionsand touch the START/RESETpad to beginthe new cgcle.

When the door is opened, the indicator lights will turn off if the START/RESETpad is not selected within 5 minutes. To activate the displag, open and close the door or touch ang pad.

Clean

PDW8000 Series

The CLEANlight is illuminated when the selected cgcle and enhancements are complete. The light will stag ON until a pad is pressedor the door is opened and then closed.

PDW9200 Series-PDW9900 Series

The CLEANlight is illuminated and a double beep will sound when the selected cgcle and enhancements are complete. You mag remove the dishes at ang time. The high-efficiencg fan will run quietly for 30 minutes to 4 hours (depending on selected cgcle)after the CLEANlight is illuminated to continue drying the dishes.The fan can be turned off bg opening the door and pressingang kegpad.

ALL MODELS:To turn off the audible end-of-cgcle signal (or re-activate it if it was previously tumed off), pressthe HEATEDDRY pad 5 times within 3 seconds. A triple beep will sound to indicate the end-of-cgcle beep option has been toggled.

Flashingdisplay lights.

Status Indicator Lights

START/RESET

What It Means

Cgcle has been interrupted bg pressingthe START/RESETpad, or there has been o power failure. Light will stop flashing after the dishwasher automatically drains out the water. The dishwasher will restart if the interruption was the result of o power failure.

Recommended dishwasher products.

GErecommends the following products for use in its dishwashers:

•For your manual detergent dispenser,Cascade® and ElectrasoF powder, liquidor gel automatic dishwasher detergents are approved.

•For your SmartDispenseTM Detergent Dispenser,use

only the recommended detergents listed on page 10of this manual,

•Jet Dry ® or Cascade Crystal Clear® rinse agents to remove spots and prevent new film buildup on your dishes,glasses,flatware, cookware and plastic. Using rinse agent also improves drg performance.

•Cascade® Plastic Booster TM to remove red staining

inside gour dishwasher that can come from some tomato-based foods.

•Cerama Brgte® StainlessSteelAppliance Cleaner

to clean the exterior stainlesssteel panel of GEand ProfileTM dishwashers (for stainlesssteel exterior

models only).