GE PDW8000, PDW9000 warranty _l_ Enhancements, _ Start, About the dishwasher control panel

About the dishwasher control panel.

_l_ Enhancements

The light above the selected pad will be ON to indicate which ENHANCEMENT has been selected.

DELAYHOURS	You can delag the start of a wash cgcle for up to 24 hours (depending on model). Press
	the DELAY START pad to choose the number of hours you want to delag the start of
	the cycle; then press START/RESET.
	PDWS000Series:The machine will count down and start automatically at the
	correct time.
	PDW9000 Series:After closing the door,the machine will count down and
	automatically start at the correct time.
	NOTE:To cancel the DELAYSTARTselection before the cycle begins, repeatedly press
	the DELAYSTARTpad until the display is blank.
ADDED HEAT	When selected,the cycle will run longerwith heating element on to improve both wash
{EXTRA HOT WASH}	and dry performance.
	NOTE:Cannot be selected with RINSEONLYcycle.
PREWASH	For use with heavily soiled and/or dried-on, baked-on soils.Thisoption MUSTbe
(on some models)	selected PRIORto starting the cycle. Thisoption adds !5 minutes to the cycle time.

NOTE:Cannot be selected with RINSEONLYcycle.

HEATEDDRY Shuts offthe drying heat option. Disheswill air dry naturally (PDW8900Series)or

Light Off fan dry (PDW9200-PDW9900Series)to saveenergy.

HEATEDDRY Turnsthe heater on for fast drying. Thiswill extend the total cgcle time by !5 minutes Light On for the ANTI-BACTERIALcycle, 38 minutes for the NORMAL,SINGLERACKWASH

and COOKWAREcycles, 8 minutes for the SPEEDcycle, !5 minutes for the PLASTICScycle and 30 minutes for all other cycles.

NOTE:Cannot be selected with RINSEONLYcycle.

LOCK Youcan lock the controls to prevent any selections from being made. Or you can lock _1 the controls after you have started a cycle.

Children cannot accidentally start dishwasher by touching pads with this option selected.

To unlock the dishwasher controls, pressand hold the HEATEDDRY pad for 3 seconds.

The light above the lock pad will turn off.To lock the dishwasher,pressand hold the

HEATEDDRY pad for 3 seconds.The light above the LOCKpad will turn on.

RESETTo change a cycle after washing starts...

PDWS000Series:Touchthe START/RESETpad to cancelthe cgcle.The START/RESETlight will flash while the water is pumped out if needed.This takes approximately 2 minutes.

PDW9000Series:Openthe door slowly to prevent splash-out. Touchthe START/RESET pad to cancel the cycle. If the START/RESETlight is flashing, closethe door until the water pumps out (thistakes approximately 2 minutes) and the light stops flashing. When the light stops flashing, the dishwasher can be reprogrammed and restarted.

_ Start

PDW8000 Series

Close and latch the dishwasher door and select the cycle and desired enhancements. Touch the START/RESETpad to begin the cycle. Water fill begins immediately, and approximately 60 seconds later the wash action begins.

When the dishwasher door is fully closed and latched, the control panel lights will display the last settings you selected. If you don'twant to change any of the settings, simply touch the START/RESET pad to begin the cycle.

If the door is closed, the indicator lights will turn off if the START/RESET pad is not selected within 5 minutes. To activate the display, open and close the door or press any pad.