Consumer Support Troubleshooting Tips Installation Instructions Care and Cleaning Operating Instructions Safety Instructions
14
Step 1—Install Anti-Tip Brace

WARNING: ANTI-TIP PRECAUTIONS:

The anti-tip brace must be installed to prevent

the drawer from tipping forward when opened

and loaded.

Failure to do so could result in personal injury.

Install 2x4 or 2x2 anti-tip brace
against rear cabinet wall 9″
from floor to bottom of brace
2x4 or 2x2 runners
or solid bottom
9″
Provide Cabinet Support
IMPORTANT: When installed below a single or
double oven, check to be sure that any oven
supports above the cutout do not obstruct the
231⁄2″required depth of the warming drawer
cutout.
■
A 2″minimum clearance between oven
and warming drawer cutouts are required.
Additional clearance may be required if
2 x 4 blocks are used to support runners or
solid floor of the oven above.
■
The warming drawer may be supported by
either a solid bottom, 2 x 4 or 2 x 2 runners.
■
The support must be level and rigidly
mounted, flush with the bottom edge
of the cutout.

■There is no way to level the drawer once it

has been installed. Be sure supports are level.

■
The entire weight of the drawer is supported
by the runners or solid floor and must be
capable of supporting 150 lbs.
231⁄2″
22″
27″
2″x 4″or equivalent runners
231⁄2″
25″
30″
2″x 4″or equivalent runners
Installation of the warming drawer.
Read these instructions completely and carefully.