GE PSB2201NSS dimensions GE Profile Advantium 240 Wall Oven, Installation, Information

PSB2201NSS

GE Profile Advantium® 240 Wall Oven

Cabinet width 4-3/16

Note: Cabinets		Cutout width	4-3/16
		25-1/8"
installed adjacent
to wall ovens must
have an adhesion	21-1/2"		23-1/2"
	Excluding

A

Junction box location (240-volt models o

B

spec of at least a	Handle	Cutout depth
194°F temperature		Junction
rating.
		box
	A	location

H	D
		2-1/2" MIN between cutouts
	Excluding
	Handle	recommended—2" MIN required
	W

Note: 2" minimum			B	(240-Volt
between cutouts		Conduit	17-1/2"	models only)
	19-1/32"
when installed		(48-1/2"	Cutout height
		long)
above warming
				Construct Solid
drawer or single
				Bottom Min.
wall oven.
	29-25/32"		Required	3/8" Plywood
Installation				Supported by
			cutout location
				2 x 4 or 1 x 2
Information:			36-3/4"
				Runners, all
			minimum
Before installing,				Four Sides.
			from floor
consult installation				(Must Support
				150 lbs.)
instructions packed
with product for ­current		30
dimensional data.

A

Conduit

(46" long)

B

Construct Solid Bottom

MIN 3/8" Plywood Supported by

2 x 4 or 1 x 2 Runners, all Four Sides. (Must Support 150 lbs. for Advantium) (Must Support 200 lbs. for Wall Oven)

9-1/4" cutout height

28-1/2" cutout width

2" MIN between cutouts

1" Min. above toekick or adjust to oven installation height

A=Allow 1" overlap of oven over top and bottom edges of cutout. B=Allow 11/16"-3/4" for overlap ov oven over side edges of cutout.

A=Allow 1" overlap of oven over top and bottom edges of cutout. B=Allow 11/16"-3/4" for overlap ov oven over side edges of cutout.

For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at ge.com or call GE Answer Center® service, 800.626.2000.

Suitable bracing to support runners

C

L

21-5/8"

over centerline of cabinet

(Must support 130 lbs.)

2 x 4’s or
					D			Z
equivalent
		Cabinet	W	H	Depth	X	Y	Cutout
solid floor
		Width	Width	Height	(excluding	Cutout	Cutout	Depth
		(inches)			handle)	Width	Height	(minimum)
	PSB2200/1 without	30	29-25/32	19-1/8	21-3/4	25-1/8	17-1/2	23-1/2
	accessory drawer
	PSB2200/1 with	30	29-25/32	22-1/4	21-3/4	25-1/8 to	21	23-1/2
	accessory drawer					28-1/2*
	*For existing cutouts a maximum width of 28-1/2" is acceptable
								Listed by
								Underwriters
								Laboratories

Specification Created 9/08 240441