GE PSC23NGNCC, PSC23NGNBB Rough-In Dimensions, Installation of Water and Electrical Outlets

TM

PSC23NGN—GE Profile Arctica™ 22.6 Cu. Ft. CustomStyle™ Side-by-Side Refrigerator with Dispenser

Rough-In Dimensions

Standard, New Construction and Replacement Installation

•All wall/floor molding should be removed prior to installation.

•Water recess on rear wall recommended to prevent water line damage. 48" minimum length 1/4" diameter water line tubing recommended.

•When possible, recess both copper water line and electrical outlet. (See local codes)

•Front and rear leveling legs are adjustable for the built-in look. (See owner’s manual)

•If optional collar trim kit is to

be used or anticipated, see collar trim installation on next page for different rough-in dimensions.

8' Ceiling

12" Soffit

13" to 14" Cabinet

70-1/4"*

24-1/2"

36-1/8"

*The rough-in dimension of 70-1/4" is minimum and is measured from the finished floor to top of opening (or the underside of the overhead cabinets). For Models with Trim Kit: If frameless style cabinets are planned for above the refrigerator, you may need to consider adding a maximum of 1/4" (70-1/2") to height of opening to allow additional clearance between cabinet doors and top of refrigerator trim when cabinet doors are in open position.

Installation of Water and Electrical Outlets

1/2"

Alternate water

line location through floor

Top View

Water hook-up

on the refrigerator

Recommended single loop of 1/4" copper water line

Allow 48" minimum water

line to enable refrigerator 24" to be pulled forward

24" Cabinet

Specification Created 11/01

ElectricalWater

3/4" Airspace

(1/2" Gap + 1/4"

Wall Plates)

25"

Counter

Top

18"

Recommended water line location using recess

in rear wall

Rear Wall View

For answers to your Monogram,® GE Profile™ or

GE appliance questions, visit our website at

GEAppliances.com or call

GE Answer Center® service, 800.626.2000.

Total volume and shelf

	VOLUME and	area are calculated by the		Listed by
	SHELF AREA
		Association of Home		Underwriters
Manufacturer Certified to		Appliance Manufacturers’	R	Laboratories
ANSI/AHAN HRF-1-1979
ASSOCIATION OF HOME
APPLIANCE MANUFACTURERS
		standards.