PROBLEM | POSSIBLE | CAUSE AND REMEDY | ||
WATER WON’T | c Make sure drain hose is not kinked. | |||
DRAIN |
| ● Top of drain outlet should be less than 8 ft. above floor. | ||
|
| |||
WATER LEAKS | ● Make sure hose connections are tight at faucets. | |||
|
| ● Make sure end of drain hose is correctly inserted in and secured to drain facility. | ||
WASHER | IS NOISY | ● Make sure washer is level and firm to the floor with rubber foot pads in place and | ||
|
| front jam nuts tight. See your Installation Instructions. | ||
|
| ● A sharp distinctive sound will be heard at the end of each spin period as the motor | ||
|
| stops and the spin brake inside the transmission “locks in? This sound is normal. | ||
|
| ● Heavily unbalanced loads can cause the washer to vibrate excessively during spin, | ||
|
| and may cause it to move from its original position. In extreme cases, (usually occurs | ||
|
| when washing a single, heavy item or a small load when water level is set higher than | ||
|
| necessary) the spin basket may strike the outer tub, creating a loud but harmless noise. | ||
|
| To correct, open the lid and redistribute the load evenly about the wash basket. Close | ||
|
| the lid and | restart. | |
WASHER | PAUSES | ● Washer | normally pauses between washing steps. . . such as between wash and spin or | |
IN CYCLE |
| between | spin and rinse. | |
If you need more help.. .cail, toll free:
GE Answer Center@ 800.6262000
consumer information service
25
