GE WA8610S operating instructions Operat~G ~Structions, Energy-Sav~G Tps

	OPERAT~G ~STRUCTIONS
	(continued)
HOW to Use the Bleach Dispenser (on models so equipped)
Use this dispenser with		● Measure bleach carefully.
liquid bleach only.	/	● Pour measured amount of liquid bleach directly
If you prefer to
		into bleach dispenser.
use powdered	d..
		● Do not overfill or allow dispenser to overflow.
bleach, pour it
		Avoid splashing. Undiluted bleach can cause
into the wash
		fabric damage.
basket along with
	%%
your detergent. Do		● Never pour undiluted liquid bleach directly
not pour powdered bleach		onto clothes or into the wash basket.
into the bleach dispenser.

HOW to Use the Filter-Flo Pan (on models so equipped)

The Filter-Flo pan is the lint filter. Position the Filter-Flo pan on the agitator after loading clothes into the washer. Lint is easily seen and removed after the wash is finished.

~.’’;:;:,,.

,.,..:. <.: .,/ .,,:, ,.,...

,.. . . .. 1~11 {!:j;,$i p,, :.:.::.,,,:,. .. .,!,.,

a

NOTE: Do not use the Filter-Flo pan as a wash basket. Do not put items to be washed in the Filter-Flo pan. Do not place detergent packets in the Filter-Flo pan.

HOW to Use the Soak Cycle (on models so equipped)

●Soak: Turn the Cycle Selector knob to soak. Start the washer. Add pre-measured detergent or soak product; add clothes.

●NOTE: For an extended soak, allow the washer to fill and agitate for a few minutes to dissolve the soaking agent. Then push in the Cycle Selector knob to stop the washer (keep lid closed) and allow to soak for as long as desired. After desired soak period, pull out the Cycle Selector knob to complete the cycle.

ENERGY-SAV~G TPS

If your clothes and household items don’t look clean and fresh after washing, you will probably rewash them.. and that means you’ll waste energy. Remember to sort your clothes carefully, and load them properly, select correct cycles, use enough detergent and choose u water temperature warm enough to re[ea.se and get rid c?f ~oil.

●Try to wash less often. Save articles of the same type of fabric until you have a full load.

●If you must wash smaller loads, adjust the amount of water. Small loads should have lower water levels.

●Always rinse in cold water. The temperature of the rinse does not affect cleaning.

●Wash in off-peak utility hours. Your local utility can tell you which are the off-peak hours.

●Use your washer’s Normal Spin. This will remove more water during spin, which will shorten drying cycle to save more energy.

10