GE Wine Chiller Replacing the light bulb, Event of a Power Failure, Preparing to Move

Instructions

Care and cleaning.

In the Event of a Power Failure

Safety

If the power fails, open the door as infrequently as possible to maintain the temperature. A gradual rise in temperature should not have any adverse effect on the wine.

If it is extremely hot, you may want to unload the wine from the wine chiller and move the wine to a cooler location until power is restored.

When power is restored, the controls automatically are set to the RED WINE setting. If needed, reset the controls to the desired setting.

Operating Instructions

Care and Cleaning

Troubleshooting Tips

Consumer Support

Preparing to Move

Unload the wine, then secure the racks by	Be sure the wine chiller stays in an upright
taping them in place to prevent damage.	position during the move.

Replacing the light bulb.

	Unplug the wine chiller.
	If the door is locked, unlock it.
	The light bulb is located behind a light shield in the ceiling of the
Bulb	wine chiller near the front. To remove the light shield, remove the
	two screws at the back corners of the shield.
Housing
	Pull down on the back of the light shield to release the two
	front tabs.
	Remove the light bulb housing by removing the two screws that
Step 5:	attach the housing to the ceiling of the wine chiller.
Remove two screws	Pull the bulb out of the receptacle. Replace with a 5 watt, 12 volt
	bulb. This type of bulb is available at most automotive parts stores.
	WARNING: Using a bulb rated higher than 5 watts may damage
	the electronic controls on the wine chiller.
	Attach the light bulb housing to the ceiling of the wine chiller with
	the two screws. Make sure not to pinch or damage any of the wires
	attached to the housing.
	Line up the light shield with the indentation on the ceiling of the
	wine chiller, then push the front of the shield up until the front tabs
	clip into place. Replace the screws at the back of the shield.

Plug the wine chiller back in.

8