CONVERTING TO LP GAS (Sealed Burner models only)
or Converting Back to Natural Gas from LP
3 CONVERTING SURFACE BURNERS
Grate
Burner Cap
Drip Pan
(on some models)
Burner Head
Electrode
1.Remove grates, burner caps and burner heads.
2. Remove the brass orifice spud inside the chimney of
each burner using a 9/32″ or 7 mm nut driver.
3. Install the orifice spuds Chimney according to one of the
following diagrams (see A or B ), for LP gas or natural gas, depending on which you are converting to.
Orifice spud
A Orifice Spuds for Converting to LP Gas:
LP orifice spuds are in a small plastic bag packed with this Use and Care Guide or on a bracket next to the pressure regulator. LP orifice spuds have a
B Orifice Spuds for Converting to Natural Gas:
Natural gas orifice spuds have a
N | N |
N | N |
Front of Range
4.To prevent leakage, make sure the orifice spuds are securely screwed into the gas inlet tubes.
5.Put old orifice spuds back in the bag or on the bracket next to the pressure regulator to save for possible future conversion.
NOTE: If an orifice spud is
accidentally dropped, the cooktop can be raised. Release
the 2 front clips with a large flat blade screwdriver and
remove the 4 screws
under the burner heads.
When lowering it, make sure it snaps over the clips.
4 CONVERT THE OVEN BURNER ORIFICES
L
Brass
L
Brass
II | I |
| |
II | III |
Front of Range
L
White
L
Brown
Oven Burner
1.Remove oven door, storage drawer and oven bottom. The lower burner orifice spud is located behind the storage drawer or kick panel. (On some models, a metal shield must be removed to access the orifice.)
2.To convert to LP gas, use 
″wrench to turn the lower 
a 1/2
burner orifice spud clockwise. Tighten the spud only until it is snug. To prevent damage, do
not overtighten the spud.
To convert to natural gas, loosen the spud about 2 turns.
(continued next page)
45
