Manuals / GE / Kitchen Appliance / Appliance Trim Kit

GE ZBD5600 White film on glasses, Hard water, Try progressively increasing the Rinse Aid, Problem

Models: ZBD5900 ZBD5600 ZBD5700

1 28

Page 22

Questions? Use this problem solver

		Before You Call For Service

				Dishwasher

PROBLEM		POSSIBLE CAUSE	WHAT TO DO

White film on glasses,		Hard water	•Try progressively increasing the Rinse Aid
tea and coffee stains			setting to 6. See the Rinse Agent section.

		Repeated use of	•Discontinue use of Sani option.
		Sani option

	Brown spots or pitting	Consistently low water	•Check operating water level is between
of stainless steel and		level in dishwasher	the MIN. and MAX. indicators on lower
tarnishing of silver			spray arm support tower. See Care and
			Cleaning section.

		Electrolysis following	•Wash scratched or worn pieces by hand.
		contact with other metals	Polish silverware with a silver-plate cleaner.

		Detergent thrown over the	•Load detergent properly. See Using the
		cutlery or saucepans	Dishwasher section.

Page 22

Image 22

GE ZBD5600 White film on glasses, Hard water, Try progressively increasing the Rinse Aid, tea and coffee stains, Problem

Contents

GE Monogram Use and Care Guide Dishwasher ZBD5600 ZBD5700 ZBD5900 Introduction ContentsConsumer Information DishwasherWrite down the model & serial numbers Before using your dishwasherIf you need service If you received a damaged dishwasherWATER HEATER SAFETY IMPORTANT SAFETY INSTRUCTIONSPROPER INSTALLATION AND MAINTENANCE Read and follow this Safety Information carefully WHEN USING YOUR DISHWASHERSAVE THESE INSTRUCTIONS Control Panel - ZBD5600 Control SettingsDishwasher Control Panel - ZBD5600 Control SettingsDishwasher What happens in each cycle based on the NORMAL Option Selection at 120F. inlet water temperatureStart a wash load Detergent Usage Guide Powder or LiquidControl Panel - ZBD5700 & ZBD5900 Cycle Status Indicators Control SettingsDishwasher NSF INTERNATIONAL for cleaning and sanitization of dishes, glasses and utensilsStart a wash load Tone Silencing Meets NSF Protocol for Performance of Domestic SprayControl Panel - ZBD5700 & ZBD5900 Auto Memory Child Lockout ModeNORMAL Option Selection at 120F. inlet water temperature What happens in each cycle based on theUpper Rack Adjusting Upper Rack HeightLoading the Racks Upper Wash TowerUpper Rack Adjusting Upper Rack HeightLoading the Racks Upper Wash TowerThe Air Gap Care and CleaningExterior Interior Protect Against Freezing DishwasherThe Air Gap Care and CleaningExterior Interior Protect Against Freezing DishwasherCare and Cleaning The Wash FiltersDishwasher The Wash Filters Care and Cleaning Light Bulb Replacement on some modelsWater fill level Maximum level Minimum level Fill time switchChange the Dishwasher’s Appearance for ZBD5600 and ZBD5700 only Optional AccessoriesDishwasher PROBLEM Questions? Use this problem solverBefore You Call For Service temperatureQuestions? Use this problem solver Cleaning section setting to 6. See the Rinse Agent sectionthe MIN. and MAX. indicators on lower Polish silverware with a silver-plate cleanerNotes for your DishwasherService Contracts Consumer ServicesService Parts and AccessoriesYOUR MONOGRAM DISHWASHER WARRANTY WHAT IS COVERED From the Date of the Original PurchaseWarranty for customers in the USA WHAT IS NOT COVEREDYOUR MONOGRAM DISHWASHER WARRANTY Warranty for customers in CanadaWHAT IS COVERED From the Date of the Original Purchase WHAT IS NOT COVEREDRegistration Ownership Product Consumer Today Mail ImportantWarranty Registration Department P.O. Box Louisville, KY Appliances GEProduct Consumer Product Ownership RegistrationFollow these three steps to protect your new appliance investment Model No

White film on glasses,

Hard water

•Try progressively increasing the Rinse Aid

tea and coffee stains

setting to 6. See the Rinse Agent section.

Repeated use of

•Discontinue use of Sani option.

Sani option

Brown spots or pitting

Consistently low water

•Check operating water level is between

of stainless steel and

level in dishwasher

the MIN. and MAX. indicators on lower

tarnishing of silver

spray arm support tower. See Care and

Cleaning section.

Electrolysis following

•Wash scratched or worn pieces by hand.

contact with other metals

Polish silverware with a silver-plate cleaner.

Detergent thrown over the

•Load detergent properly. See Using the

cutlery or saucepans

Dishwasher section.