Care and Cleaning/Optional Accessories
Dishwasher
Water Fill Level
For best performance, check the water fill level of your dishwasher.
Once the dishwasher is fully connected, run it through a complete RINSE ONLY cycle to ensure it is emptying and filling correctly. For low water pressure situations run the RINSE ONLY cycle 3 times. Halfway through the final RINSE ONLY cycle, pause the dishwasher and check the water level inside the dishwasher. If the water level is not above the minimum water level (marked on the lower spray support tower), increase the fill level.
1.Ensure the dishwasher is not running through a cycle. Depress the WATER TEMP button for ten seconds until the second buzzer sounds (except on ZBD6600 models).
2.Press the START/CANCEL button to select fill time, as per chart (65 seconds is the factory setting).
3.To test time, press DELAY START. The dishwasher will start filling. Listen for the dishwasher to complete filling. Once filled, the fill level must be checked to ensure fill time is correct.
4.Once complete, press the WATER TEMP button to exit fill time mode.
Maximum level 
Minimum level
Continue to press the
START/CANCEL button until the desired indicator is illuminated.
Cycle Status |
|
Indicators | Fill time |
|
|
SENSING | 60 seconds |
WASHING | 65 seconds |
RINSING | 70 seconds |
DRYING | 80 seconds |
CLEAN | 90 seconds |
|
|
Change the
Dishwasher’s Appearance for ZBD6400 and ZBD6500 only
You can change the door panel appearance of your dishwasher by ordering one of these optional accessories:
•1/4″ Wood Panel Trim Kit ZPF625B (Black) ZPF625W (White)
•3/4″ Trimless Panel Kit ZPF675B (Black) ZPF675W (White)
These accessories are available at extra cost by calling in the USA, 800.626.2002. In Canada, call 1.888.880.3030.
Specify accessory number when ordering.
23
