21
Water FillLevel
For best performance, check the water fill level of your
Chef’s Washer.
Once the Chef’s Washer is fully connected, run it through
a complete RINSE ONLY (on some models) cycle to
ensure it is emptying and filling correctly. For low water
pressure situations, run the RINSE ONLY (on some
models) cycle 3 times. Halfway through the final RINSE
ONLY (on some models) cycle, pause the Chef’s Washer
and check the water level inside the Chef’s Washer. If the
water level is not above the minimum water level (marked
on the lower spray support tower), increase the fill level.
1. Ensure the Chef’s Washer is not running through a
cycle. Depress the WATER TEMPbutton for ten
seconds until the second buzzer sounds.
2. Press the START/CANCELbutton to select fill time,
as per chart (65 seconds is the factory setting).
3. To test time, press DELAY START. The Chef’s Washer
will start filling. Listen for the Chef’s Washer to
complete filling. Once filled, the fill level must be
checked to ensure fill time is correct.
4. Once complete, press the WATER TEMPbutton to
exit fill time mode.
Maximum level
Minimum level
Cycle Status
Indicators Fill time
SENSING 55 seconds
WASHING 60 seconds
RINSING 65 seconds
DRYING 75 seconds
CLEAN 85 seconds
Continue to press the
START/CANCEL button until the
desired indicator is illuminated.