10
Installation Instructions
ELECTRICAL CONNECTIONS (CONT.)
CONNECT CONDUIT
With the oven supported on a table or
platform in front of the cabinet opening,
connect the flexible conduit to the electrical
junction box as shown below. Position the
conduit in such a manner that it will lie
behind the oven in a natural loop when the
oven is installed. You will need to purchase
an appropriate strain relief clamp to complete
the connection of the conduit to the
junction box.
6
NEW CONSTRUCTION AND
FOUR-CONDUCTOR BRANCH
CIRCUIT CONNECTION
•When installing in new construction, or
•When installing in a mobile home, or
•When installing in a recreational vehicle, or
•When local codes do not permit grounding
through neutral:
Cut the neutral (white) lead from the
crimp. Re-strip the neutral (white) lead to
expose the proper length of conductor.
Attach the appliance grounding lead
(green or bare copper) in accordance
with local codes. If the residence
grounding conductor is aluminum, see
WARNING under ATTENTION
INSTALLER.
Connect the oven neutral (white) lead to
the branch circuit neutral (white or gray)
in accordance with local codes, using a
wire nut.
Connect the oven red lead to the branch
circuit red lead and the oven black lead
to the branch circuit black lead in
accordance with local codes, using wire
nuts. If the residence red, black or white
leads are aluminum conductors, see
WARNING under ATTENTION
INSTALLER.
Install Junction Box Cover.
E
D
C
B
A
7
Conduit
Junction Box Location
Strain Relief Clamp
(not included) must be
used at Junction Box
Place oven on a
support to assist in
connecting conduit
Red
White
Black
Bare
Ground
Ground Wire
Junction Box Cover
Ground
Wire
TURN OFF ELECTRICITY
Turn off the circuit breaker or remove fuses to
the oven branch circuit.