Installation
Bar Refrigerator with Icemaker
Installing custom 3/4 ″ door panel and handle
(cont.)
(ZIBI240 model
Assemble overlay panels with glue and screws:
1.Center spacer panel on the backer panel, left to right and top to bottom. Secure the panels with glue.
Overlay Panel
Spacer Panel
Backer Panel
screws into the backer panel. Screws cannot protrude from the backer panel.
Screws Must
Be Countersunk
Into Panel
only)
2.Center the spacer/backer panel on the overlay panel. Secure with glue and screws. Countersink all screws into the backer panel.
Custom Panel Hinge Routing Dimensions
Use a 3/4″ router bit to cut a notch
into the back side of the assembled panel 3/8″ toward the front of the overlay panel, 3/4″ deep and 7/8″ wide.
Handle
Custom
Door Panels
4. Slide overlay panel into the door trim.
3/4″
7/8″ | Back side of | 5. Reinstall the side trim using the trim | |
3/8″ | |||
screws removed earlier. | |||
| custom panel |
3/8″ 7/8″ 3/4″
Install custom door panel and handle:
1.Open door to 90°.
2.Remove 5 screws holding trim; lift off trim. Retain screws.
6.Place the brushed decorative cover over the side trim to hide the screw heads. Ensure side trim is aligned top to bottom and front to back. Snap into place.
NOTE: For shipping purposes, the brushed decorative cover will be secured to the front of the unit.
3.A custom handle of your choice, supplied by your cabinet maker, must be installed onto the overlay panel before the panels are slid into the trim. Countersink all
15