Built-InDimensions/Installation, Product clearances

Built-In Dimensions/Installation

Bar Refrigerator with Icemaker

Product clearances

The bar refrigerator with icemaker is factory set for a 110° door swing.

When installed in a corner:

Check the model number and allow the appropriate clearance for the 90° door swing and to allow racks to slide out.

•ZIBS240 – 4″ minimum to wall.

•ZIBI240 – 4-1/2″ minimum to wall.

Check the model number and allow the appropriate clearance for the 110° door swing.

•ZIBS240 – 14″ minimum to wall.

•ZIBI240 – 16″ minimum to wall.

NOTE: Clearances are based on the recommended 2-1/4″ handle standoff depth. Custom handle clearances may vary depending on the standoff of the custom handle.

Choose the location:

•These products may be closed in on the top and three sides as long as the front is unobstructed for air circulation and proper access to the door.

14" Minimum

to Wall

(with Custom Panel 90° Door Swing 21-5/8"

16" Min.)

110° Door Swing

23-5/8"

90°

4" Minimum

to Wall

110°(with Custom Panel

4-1/2" Min.)

•Do not install these products where the temperature will go below 55°F (13°C) or above 90°F (32°C).

•Do not install where it will be subject to direct sunlight, heat or moisture.

Black or Stainless Steel Toekick Options

Your custom panel (ZIBI240 model only) bar refrigerator with icemaker is shipped with two toekicks, a stainless steel and a black toekick. For shipping purposes, one of the toekicks will be secured to the back or inside of the unit, and the second will be installed on the unit. Keep the unused toekick and other unused or removed parts for possible future use.

Installing custom 3/4 ″ door panel and handle

(ZIBI240 model only)

3/4″ Overlay Panel Dimensions

Model ZIBI240 requires a field-installed overlay door panel.

•The overlay panel must be secured to a 1/4″ thick backer panel that slides into the trim. A .10″ thick spacer panel must be placed between the overlay and backer panel.

•A custom handle of your choice, supplied by your cabinet maker, must be installed on this overlay panel. Countersink all screws into the backer panel. Screws cannot protrude from the backer panel.

NOTE: Maximum total weight for custom door panel is 25 pounds.

3/4″ Overlay Panel Dimensions (in inches)

		A (Width)	B (Height)
B	1/4″ Backer	23-3/16″	29-9/16″
	1/4″ Backer	23-3/16″	29-9/16″

	0.10″ Spacer	22-1/2″	29-1/16″

	3/4″ Overlay	23-5/8″	30″

Door

1/4"

Backer

Panel

Overlay