GE ZISW/B360DR dimensions Dimensions and Clearances in inches, The cutout depth must be

*84" From Floor to Top Frame

ZISW/B360DR – GE Monogram 36" Built-In Side-by-Side Refrigerator with Dispenser and Water Filter

Dimensions and Clearances (in inches)

The Installation Space					36" Models 12"
					42" Models 18"
					48" Models 20"
	*Finished Width
	6"
84-1/2" max	Electrical
			5"
83-1/2" min	Area
Finished						75" From Floor
Opening
						to Bottom
	24"					of Electrical
							Area
	5"	Water Supply		5"	3-1/2"

35"

Case Width 25-3/8

*83-1/2" at Rear

26-7/8"	36"
	Frame to Frame
including
handle

*Shipping height. The refrigerator can be adjusted to fit into a cutout that is 83-1/2" min. to

84-1/2" max. height Note that the top case trim at the front is 1/2" higher and will overlap upper cabinetry or soffit. Use leveling legs and wheels for a maximum 1" height adjustment.

3-1/2"

Space is the first consideration when planning the installation.

The cutout depth must be 24"

The refrigerator will project forward, slightly beyond adjacent cabinetry, depending on your installation.

Door Swing Clearances

The installation must allow for clearances to adjacent walls or cabinets. These refrigerators are equipped with a 2-position door stop. The factory-set 130° door swing can be adjusted to 90° if clearance to adjacent cabinets or walls is restricted.

The cutout depth beneath a soffit

When installed beneath a soffit, the soffit cannot exceed the 24" installation depth shown. The top case trim overlaps the bottom of the soffit.

Electrical

A 115V, 60Hz., 15 or 20 amp power supply is required. An individual properly grounded branch circuit or circuit breaker is recommended. Install a properly grounded 3-prong electrical receptacle recessed into the back wall. Electrical must be located on rear wall as shown.

13

130° Door Swing

15

90° Door Swing

23-7/8" Behind Frame

20-5/8

4" Min. to Wall

Note: GFI (ground fault interrupter) is not recommended.

Water Line

All models are equipped with an automatic icemaker. The water line can enter the opening through the floor or back wall. Route 1/4" O.D. copper tubing or GE QuickConnect kit between the cold water line and the water connection location. The copper tubing should be long enough to extend to the front of the refrigerator. The installation of an easily accessible shut-off valve in the water line is required.

Allow minimum clearances for freezer door and fresh food door for a full 130° door swing and to allow for pan removal.

•4" minimum clearance is required when door swing is adjusted to 90°. If the 90° door stop position is used, pan access is maintained, but pan removal is restricted.

•See door swing illustrations to determine interaction with adjacent cabinets or countertops.

Installation Information: Before installing, consult installation instructions packed with product, or online at Monogram.com, for current dimensional data.

Specification Revised 3/08

Listed by Underwriters Laboratories

As an Energy Star® partner, GE has determined that this product meets the Energy Star guidelines for energy efficiency.

For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at GEAppliances.com or call

GE Answer Center® service, 800.626.2000.

110108