GE Monogram 225D1804P011 Water filter, Water Filter Cartridge, When to Replace the Filter

		Water Filter
			Stainless Steel Refrigerator
Water filter	Water Filter Cartridge	5 Run 11⁄2 gallons from the dispenser to clear the
		system and prevent sputtering. See To Use the
	The water filter cartridge is
		Dispenser section.
	located in the back upper
		6 Press and hold the RESEt WAtER
	right corner of the
	refrigerator compartment.	FILtER pad for 3 seconds.
	When to Replace the Filter	NotE: A newly-installed water
		filter cartridge may cause water
	There is a replacement indicator light for the	to spurt from the dispenser.
	water filter cartridge on the temperature display.	Filter Bypass Plug
	This light will turn orange to tell you that you
	need to replace the filter soon. The filter cartridge	You must use the filter bypass plug when
	should be replaced when the replacement
		a replacement filter cartridge is not available.
	indicator light turns red or if the flow of water to
		The icemaker will not operate without the filter
	the dispenser or icemaker decreases.
		or filter bypass plug.
	On models with external dispensers, the top of	Replacement Filters:
	the LCD screen will display, “Replace Water Filter.”
		To order additional filter cartridges
	Installing the Filter Cartridge	in the United States, visit our Website,
	1 If you are replacing the	GEAppliances.com, or call GE Parts and
		Accessories, 800.626.2002.
	cartridge, first remove	Filter Model MWF
	the old one by slowly turning it
	to the left. DO NOT pull down on	Customers in Canada should consult the yellow
	the cartridge. A small amount of	pages for the nearest Mabe Service Center.
	water may drip down.

CAUtIoN: If air has been trapped in the system, the filter cartridge may be ejected as it is removed. Use caution when removing.

2Remove the protective foil from the end of the cartridge.

3Fill the replacement cartridge with water from the tap to allow for better flow from the dispenser immediately after installation.

4Lining up the arrow on the

cartridge and the cartridge holder, slowly rotate the cartridge clockwise until it stops. When the cartridge is properly installed, you will feel it “click” as it locks into place. Do not overtighten.

11