Basket removal (top drawer)
Adjustable divider in bottom freezer basket
Shelves and Bins
Stainless Steel Refrigerator
To Remove the Full-Width Basket on
Top Freezer Drawer Models:
1 Open the top freezer drawer until it stops.
2 The freezer basket rests on the inside tabs on the drawer slides.
3 Lift the front end of the basket so that the front two alignment tabs come out of the metal slide bracket first. Then rotate the front edge of the basket up while lifting the remaining two rear alignment tabs out of the metal slide bracket.
4 Make sure the plastic sleeves remain attached | Appearance may vary |
to the 4 slots on the metal slide brackets. |
|
When Replacing the |
|
| Tilt the basket back and lower it down into | Tab |
| the drawer. Rotate the basket to a horizontal position | |
| and press it down into the 4 alignment tabs. |
|
NotE: Always be sure that all 4 basket slots |
|
are engaged in the metal slide brackets before sliding |
|
back into the freezer. |
|
The freezer basket has a divider that can be both repositioned or removed.
To Remove the Divider in the Bottom
Freezer Basket:
Pull the divider forward until the rear locating tabs |
|
are out of the slots. Turn the divider slightly to the |
|
side to release the front locating tabs and lift out. | Tabs |
To Replace the Divider in the Bottom Freezer Basket:
Turn the divider slightly to one side so the tabs on the front fit into the vent slots on the basket. Position the divider so the back locating tabs snap into place in the back vent slots.
To Reposition the Divider in the Bottom Freezer Basket:
1Remove the divider as instructed above.
2Slide the divider left or right to the desired location and replace as instructed above.
13
