GE Monogram AEE18 Install the Case, Install Support Brackets and the Foam TOP Window Gasket

Window Installation Instructions

6INSTALL THE CASE IN THE WINDOW

ACarefully slide the case into the window and center the case. Lower the window behind the top mounting rail. Pull the bottom of the case forward so that the bottom mounting rail is tight against the back of the window stool. Mount the case to the window sill using 4 type E screws. Drill pilot holes, if necessary.

4 type E screws

Stool

B	Make sure the bolts
	and nuts are all of the
	way in both the left	Bolt and nut
	and right V-supports.
C	Position the V-supports
	on the case bottom so that
	they will be near the outside
	wall. Attach a V-support to
	each side of the bottom of
	the case using type C
	screws, 3 on each side.		V-support

DUse a wood block (obtained locally) between the leveling

bolts and the wall if the wall is weak or if the weight of the air conditioner falls between the studs in the wall.

E	Adjust the leveling
	bolts and nuts against
	the outside wall so
	that the case has a
	slight tilt to the outside.
	Tighten nuts with an
	adjustable wrench. Use
	a level; no more than a
	1/2 bubble will be the correct case slant to the
	outside.

6INSTALL THE CASE

IN THE WINDOW (cont.)

FExtend the left and right accordion panels to the vertical window sashes. Drill pilot holes and attach the top and bottom corners with 4 type D screws.

	Top mounting rail
Type D
screw	Type D
	screw

Type D screw

Type D screw

7INSTALL SUPPORT BRACKETS AND THE FOAM TOP WINDOW GASKET

ADrill pilot holes and attach the support brackets with two type D screws, one on each side.

BCut the foam top window gasket to the window width.

CStuff the foam between the glass and the window to prevent air and insects from getting into the room.

11