GE Monogram Built-In Dishwashers Slide Dishwasher Into Final Position, Installation Instructions

Models: Built-In Dishwashers

1 32
Download 32 pages 26.6 Kb
Page 10
Image 10
STEP 11 INSERT DRAIN HOSE THROUGH CABINET

Installation Instructions

STEP 11 INSERT DRAIN HOSE THROUGH CABINET

Position dishwasher in front of cabinet opening. Insert drain hose into the hole in cabinet side. If a power cord is used, guide the end through a separate hole.

STEP 13 SLIDE DISHWASHER INTO

FINAL POSITION

• Push the dishwasher the rest of the way into

the cabinet .

• Push the sides with your hands. Do not push the

dishwasher with your knee, as this will damage

Insulation

Blanket

Figure R

 

Maximum

Water

Drain Hose

Length 10'

Line

 

Drain

 

Hose

 

Power Cord

House Wiring

(If Power Cord

(If Used)

is NOT Used)

the door.

• Check that the tub insulation blanket does not get

“bunched-up” or interfere with the springs as you

slide it into the cabinet .

• Center the dishwasher in the opening.

• Front of door panel should be flush with face of

cabinet .

• Carefully open and close the door to ensure that

the door panel does not catch or rub on the cabinet

frame. Refer to Figure T below.

• If the door catches or rubs on the frame, reposition

and/or level the unit (see Step 14) until the door moves

TIP: Position water line and house wiring on the floor to avoid interference with base of dishwasher.

STEP 12 SLIDE DISHWASHER THREE-

FOURTHS OF THE

WAY INTO CABINET

IMPORTANTDO NOT PUSH AGAINST FRONT PANEL WITH KNEES. DAMAGE WILL OCCUR.

Grasp the dishwasher by its sides and slide it into the opening a few inches at a time.

 

 

 

 

 

 

 

 

 

Do not push against front door

Figure S

 

 

 

panel with knee. Damage to

 

 

the door panel will occur.

 

 

 

 

 

As you proceed, pull the drain hose through the opening under the sink. Stop pushing when the front of the dishwasher is a few inches forward of adjacent cabinets.

Make sure drain hose is not kinked under the dishwasher and there is no interference with the water line, wiring or any other component .

TIP: Make sure the dishwasher will fit in the cabinet . Check to be sure the power cable, drain hose, and hot water line are not trapped behind the dishwasher. Utility lines trapped behind the dishwasher prevent the dishwasher from being pushed fully into the enclosure.

10

freely and does not contact the cabinet frame.

Door Fits and

Swings Back

Behind Cabinet

Frame

 

Correct

 

 

 

Incorrect

 

Alignment

 

Door Catches on

 

Alignment

 

 

 

Cabinet Frame

 

 

Figure T

 

 

 

 

 

 

 

Page 10
Image 10
GE Monogram Built-In Dishwashers Slide Dishwasher Into Final Position, Insert Drain Hose Through Cabinet