GE Monogram Built-In Dishwashers Connect Drain Line, Drain Line Installation, IMPORTANT- When

Installation Instructions

STEP 17 CONNECT DRAIN LINE

The molded end of the drain hose will fit 5/8" through 1" diameter inlet ports on the air gap, waste tee or disposer.

•Determine size of inlet port .

•Cut drain hose connector on the marked line, if required, to fit the inlet port .

Figure DD

Cutting Line

1" 5/8"

IMPORTANT: Do not cut corrugated portion of hose

•If a longer drain hose is required, and you did not purchase 10' long GPF10L drain hose, add up to 3-1/2' of length for a total of 10' to the factory installed hose. Use 5/8" or 7/8" inside diameter hose and a coupler to connect the two hose ends. Secure the connection with hose clamps.

Figure EE

Hose Clamp

Coupler

Hose Clamp

NOTE: TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED 10' FOR PROPER DRAIN OPERATION.

DRAIN LINE INSTALLATION

•Connect drain line to air gap, waste tee or disposer using the previously determined method.

•Secure the drain hose to the air gap, waste tee or disposer with clamps.

Method 1—Air gap with waste tee or disposer

Insert the drain hose into the air gap as shown.

Waste Tee Installation Disposer Installation

Figure FF

Method 2—High Drain Loop with the Waste Tee or Disposer

Route the drain hose of the dishwasher to a minimum height of 32" from the floor with the supplied hanger as shown.

Fasten to underside	Fasten to underside
of countertop	of countertop

	32"		32"
18"	Min.	18"	Min.
Min.		Min.

Waste Tee Installation Disposer Installation

Figure GG

IMPORTANT— One of the above methods must be used or dishwasher will not operate properly.

IMPORTANT— When
	Remove
connecting drain line to disposer,	Hopper
check to be sure that drain plug	Plug
has been removed. DISHWASHER
WILL NOT DRAIN IF PLUG IS LEFT IN PLACE.

TIP: Avoid unnecessary service call charges. Always be sure disposer drain plug has been removed before attaching dishwasher drain hose to the disposer.

13