GE Monogram ZBd0700NII, ZBd0710NSS dimensions Dimensions and Specifications in inches

Minimum 1/2" gap for Clearance

Countertop

1/2" min.

23-3/4"

30-1/16" Min.

30-1/4" Max.

zbd0710NSS/ZBD0700NII

GE Monogram® Fully Integrated Built-In Dishwasher

Dimensions and Specifications (in inches)

•The dishwasher must be installed so that the drain hose is no more than 10 feet in length for proper drainage.

•Water and power supply should enter in the shaded area.

•Electrical and water connections are at the right front of the dishwasher. The hot water line should extend forward 30" to 40" from the rear wall. The electrical must extend forward at least 24" to reach the junction box.

•To prevent siphoning, an air gap must be used when the waste tee or disposer connection is less than 18" above the floor.

	This Wall Area
	must be Free of
34-1/2" Min.	Pipes or wires				24"	Cabinets
Underside of	5"	4"	5"	4"	Min.	Square
Countertop						and
to Floor						Plumb
					6"
		24" Min.					34"
Floor MUST							Adjustable
be Even with							to 35"
Room Floor
						*24"	24"

*Dishwasher models ZBD6890 and ZBD0700 require a 3/4" thick custom panel and will be 24-3/4" deep.

Electrical Requirements

The dishwasher must be supplied with 120V, 60Hz, and connected to an individual properly grounded branch circuit protected by a 15- or 20-amp circuit breaker or time-delay fuse.

For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at ge.com or call GE Answer Center® service, 800.626.2000.

Custom Panel for Model ZBD0700NII

These dishwashers require a field installed 3/4” thick custom panel and custom handle. An installation template is packed with these models and may be obtained in advance. Order Pub. No. 31-30569-1. Complete panel installation instructions are included on the template.

CUSTOM PANEL SIZE REQUIREMENTS HEIGHT

Panel height must be between

30-1/16" and 30-1/4".

• If the panel height is more than 30-1/4” it will prevent the door from swinging open.

• If the panel height is

less than 30-1/16” it will not cover the

dishwasher door frame.

• The top of the custom

panel must be flush with the top of the door. The 1/2” minimum gap between the top of the door and the bottom of the countertop must

be maintained.

WIDTH

Panel width must be 23-3/4".

• If the panel width is less than 23-3/4” it will not cover the dishwasher frame.

IMPORTANT: To ensure

optimum door balance performance, the custom panel must not weigh

more than 14 lbs.

Accessories for custom panel model ZBD0700

ZPR0700S door panel provides a professional-style handle on a stainless steel door panel.

ZTB700 stainless steel tubular handle for installation onto a custom panel.

Before installing refer to installation instructions for details. Pub. No. 31-30586

As an Energy Star®	Listed by
partner, GE has determined	Underwriters
that this product meets the	Laboratories
Energy Star guidelines
for energy efficiency.

Specification Revised 2/08 150048