GE Monogram ZBD3000 manual Systems Monitor Tells YOU if Certain Things are Wrong, Drain

THE SYSTEMS MONITOR

TELLS YOU IF CERTAIN THINGS ARE WRONG

DISPLAY	WHAT IT MEANS
-—	Electrical power to the dishwasher
Pk	has been interrupted but is now
and	back on.
RESET

BLOCKE1	An obstruction is preventing the
WASH	lower wash arm from turning.
ARM	This is usually caused by a utensil
	sticking through the bottom of the
	lower rack.

SLOW	The dishwasher is taking longer
DRAIN	than normal to drain the water
	out. This is usually caused by a
	blockage in the drain air gap (see
	Air Gap section), a kink in the drain
	hose, or a stopped-up drain pipe.

BLOCKE1	Similar to slow drain. This
DRAIN	indicates that the drain is so
	clogged that the dishwasher
	cannot continue to operate in a
	satisfactory manner. Dishwasher
	will stop.

DRAIN	Dishwasher will continue cycle
SENSOR	along with a drain period.
TEMP	The temperature sensor in the
SENSOR	dishwasher is not functioning
	properly. Dishwasher may
	continue to be used, but it will
	not heat water automatically.

WHAT TO DO

IF DISHWASHER WAS IN USE WHEN THE POWER FAILURE OCCURRED:

1.Unlatch the door. If the detergent cup is open, add detergent and close the cup.

2.Relatch the door and touch “START,” then immediately touch “CLEAR RESET.” (This will pump any remaining water out of the machine.)

3.Select the desired cycle and rerun the load.

IF THE DISHWASHER WAS NOT IN USE:

1.Latch door.

2.Select desired cycle.

3.Run cycle when desired.

1.Unlatch door.

2.Check the lower rack for any item that could block the wash arm and reposition it.

3.Relatch door.

NOTE: If the wash arm is not blocked and “WASH ARM BLOCKED” display still appears, you may start wash cycle by pressing START pad a second time.

This dishwasher is designed to automatically compensate for longer than normal drain times, but cycle time will be extended. If this code continues to appear frequently:

1.Clean the air gap (See Air Gap section).

2.Check for a kink in the drain hose.

3.Check plumbing for slow or stopped-up drains. (NOTE: Warranty service does not cover household drain problems.)

Locate and remove the blockage in the drain system. To pump any remaining water out of the machine:

1.Latch door.

2.Select any cycle.

3.Touch “START” and then immediately touch “CLEAR RESET.” (NOTE: Warranty service does not cover household drain problems.)

If DRAIN SENSOR repeats for the next cycle, call for service.

The temperature sensor needs to be replaced. Call for service.

NOTE: You may continue to use your dishwasher. For best results adjust your household water heater thermostat to 140°F.

10