Reversing the Door Swing
Beverage Center
To reverse the door
1. | Remove the top hinge pin using a 1/8″ |
| Allen wrench. |
2. | Lift the door off the bottom hinge. |
3. | Replace the hinge pin in the top hinge. |
Slip Shim Behind Hinge
4. | Switch the top and bottom hinges and |
| move them to the other side. If shims |
| are behind the hinges, move them with |
| the hinges. See illustration. |
5. | Insert the plug buttons into the old |
| hinge holes. |
6. | Unscrew the light trigger from the |
| bottom of the door. Insert the screws, |
| that were packed with this Use and Care |
| Guide, into the light trigger holes. |
7. | Before turning the door upside down, |
| new holes will need to be drilled for the |
| light trigger. Be careful not to drill down |
| more than 1/2″ or you may damage the |
| door glass. Measure 121/4″ from the right |
| side and make a mark. Measure 3/4″ |
| over from the first mark and make a |
| second mark. Measure 11/16″ in from |
| the front edge of the door and make a |
| mark. See illustration. This is where the |
| new holes will be drilled using a 5/32″ |
| drill bit. Install the light trigger. |
8. | Remove the top hinge pin using a 1/8″ |
| Allen wrench. |
Light Trigger
Top of the Door
11/16″
Top
Hinge
Bottom
Hinge
3/4″
121/4″
9. Turn the door upside down and place |
the door on the bottom hinge pin. |
10.Install the top hinge pin into the door with the Allen wrench.
11.Open and close the door to test the door swing. If the door drags and does not close evenly, loosen the hinge screws and slip shims behind the hinge. If shims are already behind the hinges, readjust them. Tighten screws and test again.
12.Remove the old nameplate and stick the new Monogram nameplate on the door using the template included.
Front of the Door
13
